User manual SMEG SE64BE-1

[. . . ] INTENDED USE OF THE APPLIANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DESCRIPTION OF THE APPLIANCE AND THE CONTROLS ON THE FRONT PANEL . . . . USING THE SENSORS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USING THE HOB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The electronics automatically manage the loads to limit maximum power absorbed to this level. To remain within the power limit, in some cases the hot plates will not set to maximum power or will not turn on. An alarm buzzer will activate in the event the power level selected leads to the maximum power limits stated above being exceeded. 37 Instructions for the User 6. 9 Residual heat indicator The hob is equipped with a residual heat indicator in the form of the symbol. When is displayed after the heat has been switched off, it indicates that the residual heat can be used to keep food hot or melt certain foods. The cooking zone may still be hot even after the symbol is no longer displayed. The glass ceramic surface does not heat up directly but is heated only indirectly by the bases of the saucepans. 6. 10 Cooking zones The appliance has 4 cooking zones of various power levels and diameters. Their position is clearly indicated with circles and the heat is limited to within the diameters traced on the glass. The 4 cooking zones are of the HIGH-LIGHT type; they turn on after a few seconds and their heat level can be adjusted by means of the controls on the front panel from 1 (min. ) to 9 (max. ). FRONT LEFT HOTPLATE REAR RIGHT HOTPLATE REAR LEFT HOTPLATE FRONT RIGHT HOTPLATE 6. 11 Control panel All the appliance's control and monitoring devices are placed together on the front panel. The symbols used are described in the table below. REAR LEFT COOKING ZONE / INCREASE VALUE FRONT LEFT COOKING ZONE / INCREASE VALUE DECREASE VALUE BUTTON REAR RIGHT COOKING ZONE / INCREASE VALUE FRONT RIGHT COOKING ZONE / INCREASE VALUE TIMER BUTTON LOCK SENSORS BUTTON HOB ON / OFF BUTTON STOP BUTTON 38 Instructions for the User 7. USING THE SENSORS The glass ceramic hob is controlled by means of the Touch Control sensor buttons. If necessary, activate the cooking zone selector. 6 a) Press the button until cooking level "0" is shown, or: b) Press the and buttons at the same time. The cooking zone can be switched off regardless of the power level setting, or: c) Select the on/off button . The entire hob/all the cooking zones will turn off. 8. 5 Switching off the hob 7 Press the on/off button . The hob will be completely deactivated regardless of the active settings. 8. 6 STOP function The cooking process can be paused briefly using the STOP function (e. g. To reinitiate the cooking process at the same power level, you need to deactivate the STOP function. If the timer was set, it stops and then restarts from the point where it stopped. For safety reasons, this function is only available for 10 minutes, after which the hob turns off. The cooking utensils are on the cooking zone and the desired power levels have been set. The symbol is displayed instead of the selected power level. The function is deactivated first of all by pressing the STOP button then another button of your choice (apart from the on/off button). [. . . ] Then lower the front of the hob until it is fully inserted. · 11. 7 Fixing using brackets · Fix brackets A using the appropriate screws as illustrated. · The figure to the side shows the exact holes to be used to correctly attach the hob to the work surface with brackets. 49 Instructions for the installer 11. 8 Technical information · · · · Hob model Electrical connections HOB RATING Maximum power See rating plate 220-240V~ 50/60Hz / 380-415V 2N~ 50/60Hz I See rating plate 11. 9 The rating plate Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason. 11. 10 Electrical connection The electrical connection of the hob must be installed by an authorised technician. The applicable legislation and rules for connection to the local electricity supplier must be followed. Detach the appliance from the power supply when you wish to repair it. [. . . ]