User manual SMEG SE64SNBE3

[. . . ] Please keep this manual in a safe place and pass it on to new owners for their information and safety. Safety instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Connection and operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Concerning the hob . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The glass ceramic is not directly heated in the case of an induction cooking zone; it is only heated up by heat reflected by the pan. 19 Operation Operating the keys GB The controls described here expect the pressing of a (selection) key to be followed by the pressing of a subsequent key. The next key will need to be pressed within 10 seconds, otherwise the selection will be deleted. The Plus/ Minus keys can be touched individually or be permanently pressed. Switching on the hob and cooking zones 1. Press the ON/OFF key until the power setting displays indicate 0. The stand-by dot of the cooking zone selected will light up. Use the Select/Plus key or Minus key to select a cooking level. The Select/Plus key will activate power setting 1 and the Minus key power setting 9. suitable for induction cooking 4. Put a metal cooking pot onto the cooking zone. As long as no metal cooking pot is placed onto the cooking zone, will power be supplied. Repeat items 2 to 4 in order to cook on other cooking zones at the same time. Select/Plus key stand-by dot Switching off a cooking zone 5. The stand-by dot of the cooking zone selected must light up. Press the Lock key until the buzzer sounds. The control lamp for the lock will go off and the lock will have been deactivated. Automatic switch-off (timer) The automatic switch-off device is used to automatically switch off any cooking zone after a stipulated period of time. Cooking times ranging from 01 minute to 99 minutes can be set. Switch on one or more cooking zones and set the required power settings. Then immediately enter the cooking time with the Timer key (for increasing the time). The control lamp for locating the position of a cooking zone on the glass ceramic hob will light up. · Timer indicator lamps can only blink if the cooking zones have already been switched on (power setting higher than 0). · With the timer key the display will commence at 01, and with the Minus key it will commence at 60. and the Minus key are · The setting will be reset if the Timer key pressed simultaneously (00). To program the automatic switch-off device for another cooking zone, repeatedly press the Timer key until the control lamp for allocating the position of a cooking zone on the glass ceramic hob lights up. The cooking zone will be switched off when the time has lapsed. [. . . ] · Screws may be used to fasten the clips. There is a risk of breakage if the hob is canted or subjected to stress during installation! Minimum distance to adjacent walls Cut-out dimension Outer dimensions of the hob Cable routing in rear wall Installation height Bracket · Insert the hob and align it. · From the bottom, insert the brackets with screws in the holes provided for fastening the brackets, align the brackets and screw them tight. · Tighten the screws with a hand screw driver only; do not use a battery-operated screw driver. [. . . ]