User manual SMEG SF122

[. . . ] Always pull the plug from the socket when disconnecting, do not pull on the electrical cable. Do not plug the power supply with wet hands. Never touch the machine with wet hands or feet. Never open the detergent drawer while the device is running. [. . . ] If you want to take your Laundry out, press on “Start / Pause” button. Your machine will empty the water in it and finish the programme after spinning your Laundry through the spinning revolution you have selected. Select spinning programme on programme knob. You can optionally reduce the revolution speed. You can start your machine by pressing on Start/Pause button. Your machine will finish the programme after spinning your Laundry in the spinning revolution you have selected. 25 CHAPTER 6: OPERATING YOUR MACHINE AUXILIARY FUNCTIONS 2-Washing water temperature selection You can select the washing water temperature with the washing water temperature adjustment button. Whenever you select a new programme, the maximum washing water temperature is shown on the washing water temperature display. You can gradually decrease the washing water temperature between the maximum temperature and cold washing (--) by pressing washing water temperature adjustment button. If you have missed the washing water temperature you wanted, you can return to the intended temperature by continuously pressing the washing water temperature adjustment button. 3-Auxiliary function prewash You can expose your very dirty laundry to prewashing operation prior to main washing by using this auxiliary function. When using this function, you should put detergent in front washing compartment of the detergent drawer. 26 CHAPTER 6: OPERATING YOUR MACHINE AUXILIARY FUNCTIONS 4-Auxiliary function for rapid wash This auxiliary function will enable the washing duration of your Laundry that are not very dirty to be shortened. In case you put half of or less than half of the laundry capacity of the washing programme you have selected in your machine, your machine will detect this event thanks to automatic Half-load detection system, and the programme you have selected will wash your Laundry in a shorter time to consume less energy and water. If your machine detects half load, symbol will automatically flash on electronic display. To cancel it, pressing on the auxiliary function of quick washing for once will be enough. To deactivate it, it will be sufficient to press on the same buttons for more than 3 seconds. When child lock is deactivated, symbol the electronic display will go off. on 32 CHAPTER 6: OPERATING YOUR MACHINE CANCELLING PROGRAMME Cancelling programme If you want to cancel any programme running: - Switch the programme knob to 0. - Your machine will stop the washing operation and the programme will be cancelled. - To get rid of the water accumulated in the machine switch the programme knob to any programme. - Your machine will perform the necessary discharge operation and cancel the programme. - You can run your machine by selecting a new programme. 33 CHAPTER 6: OPERATING YOUR MACHINE FINISHING PROGRAMME Finishing programme - Your machine will stop by itself as soon as the programme you have selected finishes. -Expression of “END” will flash on the electronic display. Note: Within 2 minutes after the programme has finished, your machine will extinguish the electronic display to save energy. It will reflash when pressed on a button of any auxiliary function. -When the Door Unlocked symbol flashes on the electronic display, this indicates the door can be safely opened to remove laundry. - Leave the door of your machine open to allow the inner part of your machine to dry after removing your Laundry. - Turn the water tap off. 34 CHAPTER -7: ELECTRONIC DISPLAY WARNING SYMBOLS WARNING OF WATER CUT-OFF / LOW MAINS WATER PRESSURE If symbol flashes on the electronic display: - Water tap may be closed. [. . . ] METHODS OF ELIMINATION FAILURE Lighten the load. Use the amount of detergent according to the declaration of the detergent producer. Spread the clothes inside the machine in an orderly and wellbalanced manner . Place the water drain hose in an appropriate height. (**) - By calibrating your machine for “Rinsing” programme, make an There are residues additional rinsing or of detergent on the eliminate the stains clothes. In the next washing These stains may be operation, use the There are grey caused by oil, cream maximum detergent stains on the or ointment . [. . . ]