User manual SMEG SLBE6X

[. . . ] 4 Description of the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Installation and connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Reverse door swing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Control panel - appliance with electronical regulation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · Avoid exposing the appliance to direct sunlight or heat sources. If this is not possible, place insulation between the appliance and adjacent heat source. · Bottom front corners of the appliance is fitted with handles to facilitate moving of the appliance may stand independently or adjacent to a furniture element or wall. Be sure to leave enough space for the opening of the door, to avoid damage to the appliance or injury to people. 7 142541 Connecting to power supply · Use the power cord to connect the appliance to the mains power. Wall outlet must be fitted with ground terminal (safety socket). Nominal voltage and frequency are indicated on the relevant label or rating plate of the appliance. · Mains power connection and grounding must be made in accordance to standard regulations and requirements. The appliance is able to accommodate minor temporary voltage fluctuations, which do not exceed -6% to +6%. 142541 8 Reverse door swing Required tools: socket spanner nr. After unscrewing of before fixing hinges, hold the door to prevent it from falling and damaging. Remove upper hinge cover (keep it for eventual later use), together with cover on the opposite side of the upper hinge cover (on the opposite side you will insert the attached cover during the assembly), and remove the cover on the opposite side of the upper part of the door. Unscrew upper hinge screws and remove the door from the bottom hinge. After the end of the Super Freeze process, rotate the A knob back to the desired setting. High freezer temperature alarm All models: Red signal lamp (D) signalizes excessive raise of temperature. The lamp goes off automatically if the freezer cools down to such point that there is no danger for stored food to decay. · After the first switch on the appliance has a 24-hour temperature alarm delay, in order to allow the freezer to reach the required temperature. This is to prevent unnecessary alarm reactions. Control unit I: In addition to the red LED, intermittent audible alarm is also triggered. - Turn off the audible alarm by pressing the C button. - The audible alarm is triggered every 24 hours, if the temperature in the freezer does not drop sufficiently to prevent the danger of damage to the food. 142541 12 Control panel - appliance with mechanical regulation CONTROL UNIT III A Temperature setting knob, on/off, and SF D Red LED ­ high temperature signal ON/OFF button To activate: rotate the temperature setting knob in the clockwise direction towards the Max position. When the appliance is switched on for the first time, a red LED lights up; this LED will go off when the refrigerator has cooled down to a temperature at which there is no more danger of damage to the food. The packaging should be air tight and well sealed without leaking since this could cause substantial vitamin loss and dehydration. Mark packages with following data: Type, amount and dates. It is imperative that food is frozen as quickly as possible. [. . . ] Ice formation within the freezer interior is a consequence of: · Bad door sealing; clean or replace the gasket if dirty or damaged. · Frequent opening of the door, door open too long. · Inserting hot food in the freezer. Red light is on: · Frequent opening of the door, door open too long. [. . . ]