User manual SMEG SME3100W

[. . . ] Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. [. . . ] Use 1-1/4" bit to drill opening for electric wiring. Cut out duct opening in wall or cabinet with saber saw or keyhole saw. Center hood in installation opening and trace keyhole slots onto wood filler strips on cabinet bottom. Screw four #10 x 7/8 wood screws into exact center of narrow end of traced keyhole slots. Allow 3/8" of screws to project, so that hood can be fitted into place later. DUCT KNOCKOUTS FIG. 3 ELECTRICAL KNOCKOUTS HINGE PINS FIG. 4 3 INSTALL THE DUCTWORK (This section for F30WV hoods only. F24WR and F30WR hoods skip this section and go on to "Install Range Hood") . NOTE These instructions will follow plans made on Page 2. Start at the exterior and run ductwork back to the range hood. For best possible performance, use the shortest possible duct run and a minimum number of elbows. Adjust hood so that hood front is flush with cabinet frame. Fasten wiring to hood with proper electrical connector for type of wire being used. WARNING ALL ELECTRICAL CONNECTIONS MUST BE IN ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE THE SERVICES OF A QUALIFIED ELECTRICIAN. Strip 1/2" of insulation from wires. Connect white to white, black to black, and green to prepared hole with green ground screw provided. Make sure that all wiring is safely contained inside. For easier installation, squeeze plastic lens and remove it from hood. Turn on power and check operation of fan and light. 7 FILLER STRIPS CENTER LINE SOFFIT WALL CAP CABINET FIG. 8 ROOF CAP DUCT SOFFIT CABINET 4 USE AND CARE SWITCHES The fan and light are each controlled by a rocker switch. [. . . ] 13 FILTER RETAINER FILTER TABS 5 FIG. 14 SCREWS SERVICE PARTS F30WV SERIES 3-1/4" X 10" DUCTED HOOD KEY NO. Rust on the interior or exterior of the unit. Products purchased "as-is" are not covered by this warranty. [. . . ]