User manual SMEG SNL926MX9

[. . . ] RECIRCULATION MODE: If it is not possible to discharge fumes outside, the hood can be used to filter and recycle the air. This way, air and fumes are filtered by the anti-odour carbon filters and recirculated through the aerating grids on the sides of chimney. · EN 01 INSTALLATION INSTRUCTIONS: Fig. 1 The hood is supplied with all the necessary accessories for installation. The minimum distance between the cooker and the lower part of the hood must be 750 mm for gas cookers and 650 mm for electric cookers (Fig. The hood is supplied with a motor intake (Fig 2). [. . . ] e) Fix the two supports/hooks to the wall. f) Mark the L2 holes on the wall to fix the hood safely. 4) Drill and put the anchors in the holes. g) Hang the hood on to the supports/hooks (fig. 5) and level by means of the adjusting screw (fig. 3). h) Fix the hood safe by tightening both wall anchors. Ducted mode or Recirculation mode installation: Fig. 2 Type 1 Type 2 Fig. 3 (a) Ducted mode: In the ducted mode, connect the motor outlet to the fumes outlet duct not less than 120mm diameter. Warning: if the hood is equipped with an active carbon filter, it must be removed (see page 7) Hood levelling screw (b) EN 02 Fig. 4 Recirculation mode: Leave the motor intake free. Install the active carbon filters as shown in page 6. Warning: if the hood is not supplied with an active carbon filter, it is necessary to buy it separately and assemble it before using the hood. i) Chimney assembly: Adjust the two telescopic chimneys to the required length (fig. According to your hood's model, remove one filter at a time as shown in these pictures. Wash the filters thoroughly with a non-bleach detergent, either by hand or machine. Re-assemble the filters, making sure that the handle faces the outside of the hood CARBON FILTERS REPLACEMENT: (For recirculated version only) The carbon filters can only retain odours for a limited period of time. They cannot be washed, therefore, it is recommended they are replaced at least once every six months or more frequently in the case of a heavy use of the appliance. Before starting, make sure the hood is disconnected from the mains supply. Fig. A To reach the active carbon filters, it is necessary to remove the metal filters as shown above. Use the pictures to find the carbon filter kit of your hood. Round filter: simply rotate the filters 90 degrees as shown in fig. A and then remove them from their seats. B): press enough to overcome the spring's resistance and remove the filter. Cartridge filter with bracket and threaded knob (fig. [. . . ] To replace them, remove the transparent fixture from the control panel, unscrew the lamp and screw in the new one. (b) b) Halogen lamps: G4, 20W - 12V lamps . To replace the lamp, use a screwdriver to remove the glass-supporting ring. Then remove the old lamp and insert the new one. Put the glass back, securing it with the ring. c) (c) Biax neon lamps: G23 11W lamp. [. . . ]