User manual SMEG SNL95XG-1

[. . . ] For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Dieses Produkt darf am Ende seiner Lebensdauer nicht ber den normalen Haushaltsabfall entsorgt werden, sondern muss an einem Sammelpunkt fr das Recycling von elektrischen und elektronischen Gerten abgegeben werden. Das Symbol auf dem Produkt, der Gebrauchsanleitung oder der Verpackung weist darauf hin. Die Werkstoffe sind gem ihrer Kennzeichnung wiederverwertbar. [. . . ] 1) All installation operations must be performed by qualified personnel. The appliance can be fitted below the work top or in a column unit. In both cases the dimensions specified in Table 1 must be observed. The oven is fitted in the unit as follows (fig. take out the screws A to remove the surround covers; 2. connect the oven to the electricity and gas supply and slide it into the unit; 3. secure the oven to the unit by means of 4 wood screws B; 4. refit the surround covers. Do not use the door as a lever when installing the oven. Do not exert pressure on the oven door when it is open. CAUTION: do not obstruct cooling or fume discharge apertures or vents. INSTALLATION PREMISES (fig. 2) For correct operation of the appliance, sufficient natural ventilation must be provided in the room for combustion of the gas. Installation personnel must follow the safety regulations in force in the country (UNI-CIG 7129 and 7131). The room must be ventilated directly via inlets on the outside walls (fig. 8 d'air / zuwenig Luft / falta de aire 34 ADJUSTING THE THERMOSTAT MINIMUM SETTING This operation is performed with the oven in the unit and after the electrical and gas connections have been made by qualified personnel. The operation is necessary when switching from G20 to liquid gas G30) in order to guarantee a one type of gas to another (from natural gas minimum temperature of around 150C. Sequence with metal dashboard open the oven door (the burner will ignite only with the door open); remove the bedplate (base) of the oven; operate the oven at maximum temperature for at least 2030 minutes; once the oven is on, close the door; reset the thermostat knob to 150C; remove the knob A (fig. 9); insert a screwdriver into hole B parallel with the thermostat shank and adjust the by-pass until you obtain a reduced but stable flame. This operation must be performed with the oven door closed. Use a flat blade screwdriver (fig. Simply unscrew the by-pass to adjust the minimum setting when switching from liquid gas to methane. For operation with G30/G31 (LPG) the by-pass adjustment screw must be fully tightened. IMPORTANT: after adjusting the burner, check that the flame is maintained at minimum setting as follows: 1. open and close the oven door continuously (neither too fast or too slowly); 3. if the flame goes out, adjust the by-pass setting (slightly increase the minimum setting). [. . . ] This operation must be At the end of the set cooking time, the bell will ring for 7'. It can be switched off by pressing the key once. Fig. 22) Slide the food onto the spit rod (1) between the two forks (2), securing it in a stable position by means of the forks to prevent straining the motor. Fit the spit rod into the spit motor (3) and rest it on the support provided. [. . . ]