User manual SMEG SP71VGL

[. . . ] 6 - 3 parts only for filter version): The three parts should be fixed with 2 screws, the deflector extension is adjustable and should correspond to the width of the chimney flue support, to which it is then fixed. During electrical connection ensure the power supply is disconnected at the domestic main switch. Adjust extension of the hood support structure, as the final height of the hood depends on this, and remember that with installation completed the hood must be at least 50 cm above the cook-top for electric cookers and 75 cm for gas or mixed cookers. Fix the two sections of the structure using 8 screws. [. . . ] For filter versions (13F), fit deflector F to the truss and secure it to the bracket supplied using 4 screws, then connect the exhaust pipe to the connection ring located on the deflector. Fit the nuts with fixing hooks supplied inside the top and bottom sections of the flues at the rectangular slots. Join the two top sections of the flue to cover the truss so that one of the slots on the sections is situated on the same side of the control panel and the other on the opposite side. Screw the two sections together with 4 screws (2 each side- see the plan diagram for joining the two sections). Fix the top flue assembly to the truss, near the ceiling, with two screws (one each side). Carry out electrical connection of control panel and bulbs. Make connections taking care to insert the connectors in the right way. Join the two bottom sections of the flue covering the truss using 6 screws (3 each side, see the plan diagram for joining the two sections). Insert the bottom section of the flue in its seat so that it completely covers the motor compartment and electrical connection box, then ensure it from inside the hood using two screws. Apply the 2 tabs (supplied) to cover the fixing points of the bottom flue (CAUTION!THE BOTTOM FLUE TABS ARE THE NARROWER AND SHALLOWER ONES). Cleaning The cooker hood should be cleaned regularly internally and externally. For cleaning use a cloth moistened with denatured alcohol or neutral liquid detergents. Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. Therefore we recommend oserving these instructions. Grease filter This must be cleaned once a month (and, for the model with electronic control panel, every time LED 4 starts to flash see preceding page) using non aggressive detergents, either by hand or in the dish-washer, which must be set to a low temperature and a short cycle. When washed in a dish-washer, the grease filter may discolour slightly, but this does not affect its filtering capacity. To remove the grease filter, pull the spring release handle (f) - (Fig. Only for model with electronic control panel: Once the grease filters have been cleaned, press button 1 (see preceding page) for about 3 seconds until you hear the acoustic signal (beep): the LED 4 will now stop flashing. Charcoal filter (filter version only) It absorbs unpleasant odours caused by cooking. The charcoal filter can be washed once every two months (when using the hood 2, 5 hours per day, in avarage and, for the model with electronic control panel, every time LED 5 starts to flash see preceding page) using hot water and a suitable detergent, or in a dish-washer at 65°C (if the dish-washer is used, select the full cycle function and leave dishes out). Eliminate excess water without damaging the filter, then remove the mattress located inside the plastic frame and put it in the oven for 10 minutes at 100° C to dry completely. [. . . ] Close the lamp cover (it will snap shut). Use a small screwdriver as a lever on the borders of the lamp in order to remove the lightbulb. Slide out the lightbulb to be replaced and replace with a new 12V 20W 30° Ø35 12V GU4 PHILIPS STANDARD LINE code 425409. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. [. . . ]