User manual SMEG SPA 42016

[. . . ] Com manuals search engine CAREFULLY READ THIS INSTRUCTION MANUAL Failure to read or fully understand the instruction manual, or incorrect interpretation of the instructions herein may cause damage to the appliance as well as being a source of danger for the operator and lowering the performances provided by the machine to a considerable extent. The manufacturer declines all liability for uses differing from those listed below. The appliance must only be installed, serviced and repaired by Smeg’s authorized personnel. The warranty provided will immediately become void if the machine issued in ways that FAIL TO CONFORM to the instructions given by the manufacturer SMEG. [. . . ] Make sure that the instruments are positioned so that they do not overlap each other; . If the instruments have articulated parts, open out the articulations as far as they will go; . Do not place instruments covered with blood or other substances that have been allowed to dry, into the trolleys; . Bulky instruments must be put in the baskets in a manner that prevents “shadow areas” from being created, as these areas obstruct cleaning of other instruments; . instruments with cavities (flexible tubes , respiration systems , etc. ) must have the possibility of being completely rinsed, even internally. Therefore, inserts with washing devices designed specifically for treating this type of instrumentation must be used; . Position the instruments so that they are unable to obstruct the spraying arms. 2 It is essential for the water to be of a good quality. Have the water in the water supply system periodically checked. Connect the demineralized water supply when possible (conductivity < 8-10 μS). It may be advisable to increase the amount of water used for each phase (by means of the relative menu), depending on the washing trolley and program selected; this parameter may not be changed for Smeg’s programs. 3 By operating correctly, the washing pump ensures that the pressure in the machine’s hydraulic circuit is correct. An alarm message will appear on the display if the pressure is incorrect. 4 The optimum temperature at which washing takes place depends on the type of detergent used and the instruments to process. However, washing temperatures must usually exceed 50°C, otherwise the chemicals will be inefficacious. Com manuals search engine Manuale GW3060 - User Detergents used 7. 5 The detergents used represent the most important factor for obtaining an optimum washing result. Smeg guarantees that optimum washing results are obtained so long as the customer uses the products tested along with the appliance. Smeg has prepared two groups of programs that differ as to the type of detergents used: both groups provide optimum washing and disinfecting results, depending on the case in question. Here are the products for which Smeg guarantees the envisaged washing results: alkaline detergents: acid neutralizers: soda caustic 33%: anti-foam agent: Smeg’s DETERLIQUID D and D2 Smeg’s ACIDGLASS P and P2 to be supplied by the end-user Smeg’s F1-S or F2-S Handle cans containing detergents with care: always wear protective gloves when transferring liquids, topping up and inserting the suction devices. Wash the affected area immediately with water if detergent substances splash on to the skin. [. . . ] Clean the filter and set it back in position. It is advisable to check and clean it when the coarse filter is inspected. Use a brush and hot water to clean this filter perfectly. Circular filter Proceed as described below to disassemble this filter: • hold the coarse filter by its lobes and turn it in the anti-clockwise direction (fig. [. . . ]