User manual SMEG SPR864AGH

[. . . ] • Never use the hood for purposes other than for which it has been designed. • Never leave high naked flames under the hood when it is in operation. • Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. • Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. [. . . ] above the cooking hob; • As shown, mark a reference point at 808 mm above the horizontal reference line, and at X mm (X= see table in figure) to the right of the vertical reference line. • Repeat this operation on the opposite side, checking levelling. • Drill the points marked using a ø 12 mm bit • Insert plugs with screws and brackets 11a in the holes then tighten them. 550 mm min 808 250 Rear air outlet zone EN 1 14 Hood body assembly • Adjust the two screws Vr of brackets 11a, by just placing them in position. • Hook the hood body to the two brackets 11a. • Pull the Comfort Panel to open it, remove the filters one by one, push them towards the rear part of the unit and pull downwards at the same time . • From inside the hood body, tighten the screws Vr to level the body. 11a Vr Connection AIR OUTLET IN A DUCTING HOOD VERSION When installing the hood in ducting version, basing on the installer’s choice, a rigid or a flexible pipe with a ø 150 or 120 mm is used in order to connect the hood to the air outlet piping. The pipe connection can be made on the upper part or on the rear side of the hood. Before connecting the hood to the air outlet ducting remove the lateral air outlet grid 8 and the plastic tube 7. The adapting flange 9 has to be removed only in case the connecting diameter is 150. REAR AIR OUTLET • When drilling the air outlet hole in the wall proceed in accordance with the scheme in the part concerning the wall drilling. • Use a pair of tongs when breaking the rear air outlet hole in the wall. loads turned off (Motor and Lights), to enable/disable 1 flash, Remote control Disabled. T3 Turn the suction motor on at speed three. Press and hold the button for 2 seconds to activate intensive speed. This speed is timed to run for 10 minutes. At the end of this time the system will automatically return to the speed set before. T4 Press and hold the button for approximately 2 seconds to On. activate automatic shutdown with a 30' delay (Motor+Lights). Press and hold for approximately 5 seconds to 2 Flashes of the Leds (L1-L2-L3) enable/disable the Activated Charcoal Filter alarm. 1 Flash of the Leds (L1-L2-L3) Filter Alarm Disabled. On. EN 1 17 MAINTENANCE Cleaning the Comfort Panels • Pull the Comfort Panel to open it. • Disconnect the panel from the hood canopy by sliding the fixing pin lever. [. . . ] Activating the alarm signal • In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a later date. • Press and hold the Delay button (T4) on the keypad for 5 seconds and the following will be displayed: • Leds (L1-L2-L3) flash twice – Activated Charcoal Filter saturation alarm ACTIVATED. • Leds (L1-L2-L3) flash once – Activated Charcoal Filter saturation alarm DEACTIVATED. CHANGING THE ACTIVATED CHARCOAL FILTER Resetting the alarm signal • Press button T1 (see the paragraph on Use). [. . . ]