User manual SMEG SRA20NE2

[. . . ] INSTRUCTIONS FOR USE BEFORE USING THE APPLIANCE SAFEGUARDING THE ENVIRONMENT PRECAUTIONS AND GENERAL RECOMMENDATIONS IF THE APPLIANCE IS NOT GOING TO BE USED MAINTENANCE AND CLEANING STORING, FREEZING AND THAWING FOOD DESCRIPTION OF THE APPLIANCE "MULTIFLOW" AIR DISTRIBUTION GUIDE TO THE INSIDE PARTS USING THE APPLIANCE USING THE ICE AND WATER DISPENSER USING THE AUTOMATIC ICE-MAKER CHANGING A WATER FILTER CARTRIDGE TROUBLESHOOTING GUIDE 21 BEFORE USING THE APPLIANCE Your new appliance is designed exclusively for domestic use. After unpacking the appliance, make sure it is not damaged and that the door closes properly. Any damage must be reported to the dealer within 24 hours of delivery of the appliance. Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. [. . . ] The function will automatically deactivate after 24 hours. It can also be deactivated manually at any time by repeating the procedure. Fast cooling (refrigerator) This function is used to speed up the cooling process for fresh foods. This function is activated by pressing the menu button until the fast cooling symbol appears on the right of the display. The symbol starts flashing and the refrigerator door icon comes on. Press OK to confirm The function will automatically deactivate after 6 hours. It can also be deactivated manually at any time, by repeating the procedure. Vacation This function deactivates the refrigerator compartment if the user is going away for sometime. This function is activated by pressing the menu button until the vacation symbol appears. The symbol flashes and the refrigerator compartment temperature disappears from the display. To reactivate the refrigerator compartment, repeat the operation. After activating the function, remove perishable food from the refrigerator compartment and keep the door closed, since the refrigerator maintains an adequate temperature for preventing the formation of odours. Note: When selecting a function, a 5 seconds interval is given to the user to press the OK button to confirm the function. Otherwise the user will have to start the procedure again by pressing the menu button. 31 USING THE ICE AND WATER DISPENSER First use When the ice and water dispenser is used for the first time, the first ice cubes and water coming out of the dispenser may have an unpleasant taste and should therefore be discarded. Ice maker The function is activated when the symbol is lit. Press the ice maker button to select the symbol corresponding to the type of ice required (cubes or crushed); the symbol will light up. Press the ice maker button and select the required type of ice. Press a rigid glass against the ice dispenser lever. Hold the glass close to the dispenser opening so that ice does not fall outside of the glass. Press lightly on the lever to activate the ice dispenser. Pressing hard will not result in faster dispensing or greater quantities. To stop dispensing, remove the glass slowly so that ice does not fall outside the glass. [. . . ] Ensure that the voltage indicated on the appliance data plate corresponds to the mains voltage. The plug of the appliance must be easily accessible even after installation so that the appliance can be unplugged if necessary. If this is not possible, connect the appliance to the mains supply by means of a two-pole switch with minimum break distance between contacts of 3 mm, fitted at an easily accessible point. If the power supply cable plug and socket are not of the same type, replace the socket. [. . . ]