User manual SMEG SRA20X1

[. . . ] INSTRUCTIONS FOR USE DESCRIPTION OF THE APPLIANCE BEFORE USING THE APPLIANCE SAFEGUARDING THE ENVIRONMENT PRECAUTIONS AND GENERAL RECOMMENDATIONS INSTALLATION HOW TO OPERATE THE REFRIGERATOR/ FREEZER FREEZING USE OF THE ICE AND WATER DISPENSER (ON SOME MODELS) USE OF THE DISPENSER LIGHT AND DISPENSER LOCK (ON SOME MODELS) AUTOMATIC ICE MAKER COMMON ICE MAKER PROBLEMS MAINTENANCE AND CLEANING VACATION TROUBLESHOOTING GUIDE/AFTER-SALES SERVICE WATER FILTRATION AND MONITORING SYSTEM (ON SOME MODELS) DISPOSAL OF YOUR OLD REFRIGERATOR ELECTRICAL CONNECTION DESCRIPTION OF THE APPLIANCE Freezer Compartment S. Top inside light (and bottom inside light on some models) Refrigerator Compartment A. Door tray (with bottle holder on some models) N. 2 litre door tray (with bottle holder on some models) O. [. . . ] Place four fingers in bucket base opening and rest thumb on the release button. Holding the base of the bucket with both hands, press the release button and lift the bucket up and out. It is not necessary to turn the ice maker control to the OFF position. The ice maker will not produce ice without the bucket installed in the door. · Normal Ice Production should produce approximately 7 to 9 batches of ice in a 24-hour period. On/Off Ice bucket care: 1. Use warm water to melt the ice if necessary. Never use anything sharp to break up the ice in the bucket. This can cause damage to the ice bucket and the dispenser mechanism. Wash the ice bucket with a mild detergent, rinse well and dry thoroughly. Do not use harsh or abrasive cleaners or solvents. NOTE: Do not turn the ice maker on until it is connected to the water supply. · It is normal for ice cubes to be stick together at the corners. · The ice maker will not operate until the freezer compartment is cold enough to make ice. · Good water quality is important for good ice quality. Water softener chemicals such as salt can damage the ice maker and lead to poor quality ice. 44 COMMON ICE MAKER PROBLEMS PROBLEM The dispenser does not work. CAUSE The freezer compartment door is open. The ice bucket is not properly installed. The dispenser has not been used for extended periods, causing the ice cubes to melt together. SOLUTION Close the freezer compartment door. Make sure that the bucket is pushed all the way in. Shake the bucket occasionally to keep cubes separate and to increase storage capacity. Throw old ice cubes away and make a new supply. Wait about 3 minutes for the dispenser motor to reset. [. . . ] · Connect the transition connector (2) to the household water supply (3). · Make sure that the water tube is not twisted. · The appliance is pre-set for operation at pressures between 1. 7 and 8. 1 bar (25 and 117 PSI). · The appliance does not require any adjustment or water drain. 23 ELECTRICAL CONNECTION Regulations require that the appliance is earthed. [. . . ]