User manual SMEG SRA25X

[. . . ] Installation and the electrical connection must be carried out by a qualified technician, according to the manufacturer's instructions and local safety regulations. Clean the inside of the appliance before using it. SAFEGUARDING THE ENVIRONMENT 1. Packing The packing material is 100% recyclable and bears the recycling symbol. For disposal, comply with the local regulations. [. . . ] With the symbol flashing, press OK to confirm your selection. This function enables to use the freezer compartment to cool drinks. When the function is selected, the icon is animated. 30 minutes after activation (the time needed to cool a standard 0. 75 litres bottle without breaking it), the icon will flash and the acoustic signal will come on. Remove the bottle and deactivate the function by pressing OK. Control panel lock function This function prevents accidental changing of appliance settings or switching off. The function is set by pressing the °C freezer and the °C refrigerator buttons at the same time for 3 seconds: the symbol will come on and an acoustic signal will activate. To deactivate the function, carry out the same procedure until the symbol goes off. Automatic ice-maker control panel lock This function consists of deactivating ice and water dispensing for easier cleaning or to prevent unintentional use. The function is set by pressing the ice maker and the light buttons at the same time for 3 seconds: the symbol will come on and an acoustic signal will activate. To deactivate the function, carry out the same procedure until the symbol goes off. Hold the glass close to the dispenser opening so that ice does not fall outside of the glass. Press lightly on the lever to activate the ice dispenser. Pressing hard will not result in faster dispensing or greater quantities. To stop dispensing, remove the glass slowly so that ice does not fall outside the glass. Do not use fragile glasses to dispense ice. Water dispensing To dispense water press a glass against the water dispenser lever, removing the glass to stop dispensing; at the same time the light inside the dispenser comes on, and goes off when the lever is released. It is not necessary to press hard on the levers to activate the dispenser. Pressing hard will not result in faster dispensing or greater quantities. 32 USING THE AUTOMATIC ICE-MAKER After switching on the refrigerator, it usually takes overnight for the first ice cubes to form. When selecting crushed ice, the cubes are crushed just before being dispensed, therefore the crushed ice may come out with a slight delay. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed ice to ice cubes, a small amount of crushed ice may come out together with the first cubes. [. . . ] · The appliance does not require any adjustment or water drain. ELECTRICAL CONNECTION Regulations require that the appliance is earthed. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the prescriptions. Make sure that the installation and the electrical connection are carried out by a qualified technician according to the manufacturer's instructions and local safety regulations. If your new appliance is provided with a plug with no earth wire, connect your green/yellow earth wire (A) to the earth screw located on the appliance (B) (see figure). [. . . ]