User manual SMEG SUK92CBL9

[. . . ] INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. [. . . ] 60 cm. ) Bruciatore Portata termica nominale (kW) Diametro Ugello 1/100 mm Auxiliary S Semi rapid Rapid Triple crown Oven Grill 1. 0 1. 75 3. 0 3. 2 3. 2 3. 0 Portata termica nominale (kW) 50 65 85 91 87 87 LPG ­ G30/G31 28/37 mbar By-pass mm 1/100 30 33 45 65 48 // Portata ridotta (W) 350 450 800 1500 850 // Portata g/h G30 73 127 218 233 233 218 Portata g/h G31 71 125 214 229 229 214 Bruciatore NATURAL GAS ­ G20 20 mbar Diametro Ugello 1/100 mm Portata ridotta (W) 350 450 800 1500 850 // Auxiliary Semi rapid Rapid Triple crown Oven Grill 1. 0 1. 75 3. 0 3. 5 3. 2 3. 0 72 97 115 133 130 130 3. 5 Arrangement of the burners on the hob (Mod. Triple crown 10 Instructions for the installer 4. FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids. Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new gas. This label is in the packet together with the nozzles. 4. 1 Regulation of the hob burner minimum level for natural gas Light the burner and turn it to the minimum position . Extract the gas tap knob and turn the adjustment screw at the side of the tap rod until the correct minimum flame is achieved. Replace the knob and check burner flame stability: (rapidly turning the knob from maximum to minimum position, the flame should not go out). Repeat the operation on all the gas taps. For models with valves, keep the knob at minimum level for about 1 minute to keep the flame lit and to activate the safety device. 4. 2 Regulation of the hob burner minimum level for LPG In order to adjust the minimum with LPG, the screw at the side of the tap rod must be turned clockwise all the way. The bypass diameters for each individual burner are shown in paragraph "3. 2/3. 4 Burner and nozzle characteristics table". Once the regulation has been completed, restore the seal on the by-passes using paint or similar materials. 4. 3 Mounting the rear top skirtboard (where applicable) · · · Loosen nuts B. Fans cause a steady outflow of air from above the door which may continue for a brief period of time even after the oven has been turned off. 7. 3 Use of the electric grill For short cooking procedures, such as the final crisping of meat which is already cooked, and turn the thermostat knob to the maximum temperature. select the static grill function The fan grill function (certain models only) allows actual cooking procedures to be carried out, thanks to the fan function which ensures that the heat penetrates into the food. For this and turn the thermostat knob to the ideal cooking cooking mode, select the fan grill function temperature (never set at more than 200° C). 7. 3. 1 Operation of the grill + rotisserie Both the static and the fan grill functions can be used for cooking in combination with the rotisserie. Fit or or fan grill the spit rod into the rotisserie bushing, select the thermostat knob to the temperature of choice (never set at more than 200° C). function and turn the All cooking procedures with grill + rotisserie must be carried out with the door closed to prevent the knobs and front panel of the appliance from overheating. 17 Instructions for the user 7. 3. 2 Using the rotisserie in cookers with maxi oven Fit the supporting frame onto the second runner up from the bottom so that the seat to take the rod projects outside the oven. Place the rod as shown in the diagram (1) and push the frame into the oven until the end of the rod reaches the hole in the rotisserie motor. Now push the rotisserie rod to the left until it reaches the position shown in the diagram (2). this function, turn the knob to ( These operations must be carried out with the oven switched off and cold. When cooking is over, use the tool provided to 1 extract the rod from the hole (3) and remove the frame (4) to bring the rotisserie rod out of the oven cavity. 2 3 4 How to use the grill Food should be flavoured and basted with oil or melted butter before cooking. An oven dish should be used to contain the sauces. [. . . ] Use normal non-abrasive products for steel, and a wooden or plastic tool if necessary. Rinse thoroughly and dry with a soft cloth or deerskin. Do not allow residues of sugary foods (such as jam) to set inside the oven. If left to set for too long, they might damage the enamel lining of the oven. 10. 2 Cleaning of the hob components 10. 2. 1 Grids Remove the grids and clean them in warm water with a non-abrasive detergent, taking care to remove any encrustations. [. . . ]