User manual SMEG SWM107PTS

[. . . ] THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE. DO NOT DISCARD PACKING IN THE HOME ENVIRONMENT. SEPARATE THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST SELECTIVE WASTE COLLECTION CENTRE. THE APPLIANCE MUST BE CONNECTED TO EARTH IN COMPLIANCE WITH ELECTRICAL SYSTEM SAFETY REGULATIONS. [. . . ] The oven is fitted with an H07RN-F three-core cable for operation at 220240V and a power supply plug. The supplied cable is a H07RN-F 3 x 1. 5 mm2 three-core cable. The power supply cable must be replaced by the manufacturer or by an authorised service centre to prevent any risks. The terminal marked with this symbol connects parts together that are normally at zero potential. Connect the appliances appropriately using this terminal in order to make sure that they are equipotential. The plug and wall-mounted socket must be of the same type (in accordance with CEI regulations). Make sure that the supply line is suitably earthed. Avoid use of adapters and shunts. 21 Instructions for the installer 2. 2. 1 Safety thermostat The oven is equipped with a safety device that takes action in case of serious malfunction. To re-arm the safety device you must contact the technical assistance service. The manufacturer declines all responsibility for damage to persons or things caused by the non-observance of the above prescriptions or deriving from tampering with any part of the appliance. 2. 3 Levelling Level the oven on the ground using the four adjustable feet. In order to adjust them, loosen the lock nut and unscrew the foot. The adjustment screws have a range of 10 mm. 2. 4 Steam outlet pipe An exhaust pipe is fitted on the back of the oven to allow the discharge of steam during cooking. During the last minute of cooking, only the countdown of the remaining 60 seconds will be displayed. At the end, a beep and the text "End" flashing (for 20 minutes) will indicate that the cooking has been completed. To return to the "OFF" status keep the "STOP" button pressed for 4 seconds. · · · · · · 4. 4. 1 Extending a cooking operation When a cooking operation finishes, it is possible to extend it manually: · While the display is showing the message "End", press the "START" button; the text "tP00" will appear on the display. · · · Turn the knob to the or symbols to set the additional minutes of cooking; at most 20 extra minutes are allowed. To start cooking with the extra time that has just been set, press the "START" button for at least 2 seconds. At the end of cooking, the text "End" will continue to flash for the next 20 minutes and the oven light will remain on. 25 Instructions for the User 4. 5 Manual cooking The manual program is "P40" and can be edited by the user, but does not save the cooking parameters set in memory. To select this program proceed as follows: · Save the program temporarily, as described in chapter 4. 3 Editing / saving a program. Unlike saved programs, the cooking time can be set to infinite; the display will show the text "InF". After saving it, do NOT return to the "OFF" condition. The appliance will perform a pre-heating cycle, showing the text "PrEh" on the display. When preheating is finished, a series of beeps lasting 3 seconds indicate that is possible to proceed with the cooking operation. [. . . ] Press the "PUSH" button; the display will show the minutes flashing. Turn the knob to the or symbols to set the minutes. Press the "PUSH" button to exit from the data setting and saving phase. The text "PEnd" appears on the display and after 3 seconds it will display P39, the temperature and the pre-heating start time in succession. [. . . ]