User manual SMEG SX91VJME9

[. . . ] • Children must never play with the appliance. • Never rest metallic objects such as knives, forks, spoons and lids on the appliance during use. • Switch off the appliance immediately after use. • Never try to put out a fire or flames with water: Turn off the appliance and smother the flames with a fire blanket or other appropriate cover. [. . . ] After lighting, keep the knob pressed down for a few seconds to allow the thermocouple to heat up. In case of accidental extinguishing, turn the knob to the off position and do not try to light the burner again for at least 60 seconds. 17 EN Manual ignition: Presence of electrical voltage Use Using the gas grill Electronic spark ignition: 1. Press and turn the gas grill knob anticlockwise between MIN and MAX. The electric spark ignition is activated automatically. After lighting, keep the knob pressed in for a few seconds to allow the thermocouple to heat up. If the burner does not ignite after 15 seconds, stop attempting to light it, leave the oven door open and do not try to light it again for at least 60 seconds. In the event of a power supply failure the cooling fan does not work. The gas oven and the gas grill must never be used at the same time. Functions list Gas burner The heat coming just from the bottom allows you to complete the cooking of foods that require a higher bottom temperature, without affecting their browning. Perfect for cakes, pies, tarts and pizzas. Grill The heat coming from the gas grill gives perfect grilling results above all for thin and medium thickness meat and in combination with the rotisserie (where fitted) gives the food an even browning at the end of cooking. Pour some non-abrasive detergent on a damp cloth and wipe down the surfaces. Dry with a soft cloth or a microfibre cloth. Cleaning the hob grids, flame-spreader crowns and burner caps 1. Clean them with warm water and nonabrasive detergent. Dry thoroughly with a soft cloth or a microfibre cloth. The continuous contact between the grids and the flame can cause modifications to the enamel over time in those parts exposed to heat. This is a completely natural phenomenon which has no effect on the operation of this component. Cleaning the igniters and thermocouples • If necessary, clean the igniters and thermocouples with a damp cloth. 4. 1 Instructions Improper use Risk of damage to surfaces • Do not use steam jets to clean the appliance. • Do not use cleaning products containing chlorine, ammonia or bleach on steel parts or parts with metallic finishes on the surface (e. g. anodizing, nickel- or chromium-plating). • Do not use abrasive or corrosive detergents (e. g. [. . . ] Pressure on the open door Risk of damage to the appliance • Never use the oven door to lever the appliance into place when fitting. • Avoid exerting too much pressure on the oven door when open. Heat production during appliance operation Risk of fire • Veneers, adhesives or plastic coatings on adjacent furniture should be temperature-resistant (no less than 90°C). This appliance may be installed next to walls, one of which must be higher than the worktop, at a minimum distance of 50 mm from the side of the appliance, as shown in figures A and C relative to the installation classes. [. . . ]