User manual SMEG SX91VLSA

[. . . ] Contents 1 2 3 4 5 6 7 8 9 INSTRUCTIONS FOR SAFE AND PROPER USE _______________________________4 INSTALLATION OF THE APPLIANCE ________________________________________6 ADAPTATION TO DIFFERENT TYPES OF GAS _______________________________10 FINAL OPERATIONS ____________________________________________________13 DESCRIPTION OF FRONT PANEL CONTROLS _______________________________15 USE OF THE COOKING HOB______________________________________________17 USE OF THE OVEN _____________________________________________________19 CLEANING AND MAINTENANCE ___________________________________________22 EXTRAORDINARY MAINTENANCE _________________________________________24 THESE INSTRUCTIONS ARE VALID ONLY FOR END USER COUNTRIES IDENTIFICATION SYMBOLS APPEAR ON THE COVER OF THIS MANUAL. WHOSE INSTRUCTIONS FOR THE INSTALLER: these are for the qualified technician who must carry out a suitable check of the gas system, install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. 3 Introduction 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. [. . . ] The flame is lit by turning the knob anticlockwise to the minimum flame setting, while simultaneously pressing the burner ignition button. In the models not equipped with the burner ignition button to light the burner just press and turn the knob. The cooking temperature is selected by turning the knob anticlockwise to the desired setting, between Min. For information on how to ignite the gas oven, see point " 7. 2 Use of the gas oven". GAS GRILL KNOB This knob is used to ignite the grill gas burner inside the oven. The flame is lit by turning the knob anticlockwise to the minimum flame setting, while simultaneously pressing the burner ignition button. In the models not equipped with the burner ignition button to light the burner just press and turn the knob. To adjust the flame, turn the knob to the zone between the maximum and the minimum settings. To turn out the burner, return the knob to position. the For information on how to ignite the gas oven, see point "7. 3 Use of the gas grill ". MINUTE COUNTER KNOB Turn clockwise to wind up the alarm and set to the desired time. Time is expressed in minutes (maximum 55 minutes). Adjustment is continuous so that intermediate times between markings can also be set. Alarm activation at end of pre-set time does not turn off the oven (no end of cooking). OVEN LIGHT SWITCH (on some models only) This switch allows the light inside the oven to be switched on at any moment. FUNCTION KNOB (on some models only) The function knob allows to switch on the oven light or to activate the rotisserie motor. 16 Instruction for the user 6 USE OF THE COOKING HOB 6. 1 Lighting of the cooking hob burners Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples. Before lighting the burners lift the glass cover; before lowering the cover, turn off all the burners and wait for them to cool down. The optional rack B is for use with "woks" (Chinese pans). To prevent deterioration of the hob we have equipped the cooker with a raised pan stand C to be placed underneath pans more than 26 cm in diameter. The supplied reduction C is also used for small pans. The drawing next to each knob shows the corresponding burner. The appliance has an electronic lighting device. In the models not fitted with a burner ignition button, simply press and turn the knob anticlockwise to the minimum flame symbol , until the ring is lit. In the models fitted with a burner ignition button turn the knob as described earlier, while pressing the button at the same time. Hold the knob down for a few seconds to allow the thermocouples to heat up. The burner may go out when the knob is released: this is because the thermocouple has not been sufficiently heated. Repeat the operation holding down the knob for a little longer. [. . . ] If left to set for too long, they might damage the enamel lining of the oven. 8. 2 Cleaning the cooking hob components 8. 2. 1 The glass cover The cover can be removed from the hinges by lifting it upwards when it is open. If liquids are spilt on the closed cover, remove them thoroughly with a rag before opening it. 8. 2. 2 Racks Remove the racks and clean them in warm water with a non-abrasive detergent, taking care to remove any incrustations. Continuous contact of the racks with the flame can cause the paint near the hot areas to be altered. This is completely natural and does not compromise the functionality of the component. [. . . ]