User manual SMEG TLS106

[. . . ] Programme selector Time display "Start delay" button "Spin" button "Start/Pause" button Programme sequence indicator "Reset" button "Door open" indication PROGRAMME CHART B J K F This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately: I. "Water tap closed" indication K. "Clean pump" indication 1) 2) 3) H I G C Max. Load kg Cotton 40 - 60 - 95 °C Cotone 40 - 60 - 95°C 6. 0 Type of wash / Notes D A E 4) Do not use liquid detergent for main wash if you have activated prewash option. [. . . ] · If the flexible hose is damaged, unplug the washing machine from the mains immediately, turn off the tap and replace the hose. If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales Service or from your dealer). Connect the water drain hose 1. Unhook the drain hose from the left clip, see arrow "A" on picture. Important: Do NOT loosen the drain hose from the right connection, see arrow "B" on picture. Otherwise, there is the risk of leakage and of scalding with hot water. Fix the "U" bend ("C") at the very end of the drain hose. Connect the drain hose to the siphon or hook it over the edge of a sink with the "U" bend and fix it properly. The edge of the sink must be no more than 100 cm from the floor. If you need to add an extension, use a flexible hose of the same size and secure the unions with screw-on hose clips. Maximum overall drain hose length: 2. 50 m. Maximum drain height ("U" bend): 100 cm. Important: Make sure there are no kinks in the drain hose and take precautions against it falling while the washing machine is running. A B C GB 4 ELECTRICAL CONNECTION Do not use extension leads or multi sockets. Electrical connections must be made in accordance with local regulations. 1) Warning - this washing machine must be earthed This washing machine is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity. If the fitted plug is not suitable for your socket outlet, or if the machine's mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below. Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a socket. 2) CONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician The wires in the mains lead are coloured in accordance with the following code: BLUE - "NEUTRAL" ("N") BROWN - "LIVE" ("L") GREEN AND YELLOW - "EARTH" ("E") To fit a new plug, proceed as follows: 2. 1) Polarized Plugs (e. g. 3 pin, 13 amp plug conforming to BS 1363A) a. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter "E" or by the Earth symbol or coloured green and yellow. The BLUE wire must be connected to the terminal which is marked with the letter "N" or coloured blue. The BROWN wire must be connected to the terminal which is marked with the letter "L" or coloured brown. 2. 2) Non-polarized plugs (e. g. 2 pin with side earth contact) The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. [. . . ] "Water level too high" (after programme cancellation or false operating). Switch off appliance and then switch it on again, select programme "Drain" and start within 15 sec. "Waterstop fault" Switch off appliance, pull out mains plug and turn water tap off. Tilt appliance forward carefully to allow collected water to flow out from the bottom. [. . . ]