User manual SMEG UW5757D

[. . . ]  The water supply pressure, measured with open valve, has to vary between 1 and 4 bars. If the water supply pressure is lower than 1 bar, install a booster pump with delivery of 30 litres/min; if it is higher than 4 bars, a pressure reducer set at 4 bars maximum has to be installed.  The water hardness has to be between 8° and 14° F (0, 8-1, 4 mmol/l). [. . . ] Check that the boiler thermometer (A) and the tank thermometer (C) are at the preset temperatures. During the installation, when the Break Tank is empty, switch on the appliance and keep the door open, so that the Break Tank fills up before putting the kitchenware into the appliance. The internal thermostats are set by the manufacturer at the following temperatures:  boiler temperature: 78° C;  tank temperature: 55° C. 22 WASHING CYCLE  Open the dishwasher door.  In order to achieve the best washing results, remove all the solids from the kitchen utensils, empty pots and saucepans, and soften any encrustations with specific products. Then, place the kitchenware in the baskets.  Ice cream basins, pots, pans, buckets, saucepans and other kitchenware are to be placed in the basket with their concave part downwards; ladles and similar kitchen utensils are to be placed in their suitable container provided as standard equipment.  Slide the basket into the dishwasher and shut its door.  Select the washing cycle:  When it is switched on, the dishwasher is automatically ready to carry out the short washing cycle, suitable for kitchenware not particularly dirty. This operation is indicated by the lighting of the lamp (H).  Push the button (G) in order to select the long washing cycle. This operation is signaled by the turning off of the lamp (H) and the turning on of the lamp (I).  Push again the button (G) in order to select the continuous washing cycle, suitable for kitchenware particularly dirty and encrusted. This operation is signaled by the turning off of the lamp (I) and by the turning on of the lamp (L).  Push again the button (G) in order to select again the short washing cycle. This operation is signaled by the turning off of the lamp (L) and by the turning on of the lamp (H).  After the washing cycle is started, it is not possible to change from the short cycle to the long cycle or vice versa. The dishwasher begins the washing and rinsing cycles automatically, as shown by the blinking of the lamp (H), (I) or (L), and it starts the rinse-aid dispenser automatically. Between the washing and the rinsing there is a dripping pause. [. . . ] The plugs present a bayonet coupling and can be easily removed turning them anti-clockwise towards the letter “A”, as shown on the plug itself. DRAIN PUMP After emptying the machine through the drain pump, clean the drain pump filter carrying out the following operations.  Stop the electric feeding of the machine.  Remove the drain pump filter and hold the water that is remained inside the pump. [. . . ]