User manual SMEG WD2050D

[. . . ] Freezer is used in households for freezing fresh food and storage of frozen food for up to one year (depending on the type of food). Before first operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Description of the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Installation and connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Reverse door swing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · Appliance with two compressors - Switch on or switch off the freezer by pressing the A button and holding it for three seconds. Switch on or switch off the refrigerator by pressing the C button and holding it for three seconds. - The temperature is indicated on the display; +9 °C for the refrigerator compartment and 0°C for the freezer compartment. These figures blink until the actual 15 142468 temperature in a respective compartment actually falls below these values. · Valve and no frost system appliance - Switch the appliance on/off by pressing the button A for 3 seconds. Both the refrigerator and the freezer are started, green signal lamps B and D are on. In this mode you can switch off the refrigerator only by pressing button C for 3 seconds (green signal lamp 2 is off). - The temperature is indicated on the display; +9 °C for the refrigerator compartment and 0°C for the freezer compartment. These figures blink until the actual temperature in a respective compartment actually falls below these values. The appliance has been preset in the factory to the recommended temperatures of the refrigerator to +5°C and freezer to -18°C. Temperature setting Temperature setting range of the refrigerator: +1°C do +9°. Temperature setting range of the freezer: -16°C do -24°C. Once the child lock is activated, only the alarm button is active. Pressing any other button provokes the letters `LL' and `L' to appear on the display. 17 142468 Control panel - appliance with mechanical regulation CONTROL UNIT V Model without fan Model with fan A Temperature setting and ON/OFF button B Illumination ON/OFF push-button 142468 18 ON/OFF button The appliance is switched on by turning the button A in clockwise direction, towards Max. The appliance is switched off when the dot is positioned against (the appliance is still powered). the Temperature setting · Temperature of the refrigerator is set with button A which can be positioned between the Min and Max range. · Recommended setting is the position between Min and Max. · If the ambient temperature around the appliance is lower than 16°C the recommended setting of the thermostat is Max. · The fan contributes to more equal distribution of temperature and faster cooling, as well as reduces formation of dew on the shelves. It only operates when the compressor is activated. · Turning on the fan is recommended as an additional function in the following cases: - increased temperature in the room (over 30°C), - increased humidity (during the summer), - when inserting larger quantities of food (rapid cooling). Fan (only with some models) 19 142468 · Turning the fan on / off ON = OFF = 0 When the fan is on, a red dot is indicated on the switch. Note: When the fan is activated, power consumption is increased and temperature in the refrigerator drops. Hence, we recommend resetting the temperature in the appliance: (dashed line), - when the fan is activated: between "Min" and and "Max". [. . . ] · Inserting hot food in the refrigerator. · Food or dish is touching the rear interior panel of the refrigerator. · Bad door sealing; clean or replace the gasket if dirty or damaged. Water dripping from the appliance: · Drain outlet is clogged, drain water drips past the collection groove. [. . . ]