User manual SMEG WHT712LCIT

[. . . ] 1 General safety instructions This section includes security instructions which may help prevent the injuries and material damage risks. All kinds of warranties shall be invalid if these instructions are not observed. 1. 1 Life and property safety u Never place the product on a carpet-covered floor. Electrical parts will get overheated since air cannot circulate from under the device. This will cause problems with your product. [. . . ] It is recommended to use special detergents produced for curtains in this programme. • Jeans Use this programme to wash clothes such as trousers, jackets, vests, etc. , made of denim. Lower mechanical movement in washing cycles and lower rpm in spinning cycles are used to prevent washing damages on stoned jeans as well as to ensure a longer life. Use this programme to wash delicates such as underwears. If there is little amount of laundry, use a laundry net. Allergy UK is the operational name of The British Allergy Foundation. The Seal of Approval endorsement, which indicates that the product bearing it specifically restricts / reduces / removes allergens from the environment of the allergy sufferer or has significantly reduced allergen content, was created in order to provide guidance for people seeking advice in this issue. It is aimed to assure poeple that products had been scientifically tested or reviewed with measurable results. Washing Machine / User’s Manual 45 / EN • Centrifuga+Scarico (Spin+Drain) Use to drain the water in the machine. 4. 3. 6 Temperature selection Whenever a new programme is selected, the recommended temperature for the programme appears on the temperature indicator. It is possible that the recommended temperature value is not the maximum temperature that can be selected for the current programme. 88 C 1888 0 88:88 Press the Temperature Adjustment button to change the temperature. Temperature will decrease by increments of 10 °C. Finally, “-” symbol indicating the cold wash option appears on the display. 1888 0 C 88:88 You can also change the temperature after the washing starts. This change can be made if the washing steps allow it. Changes cannot be made if the steps do not allow it. C C C No change can be made in programmes where temperature adjustment is not allowed. If you scroll to cold wash option and press Temperature Adjustment button again, the recommended maximum temperature for the selected programme appears on the display. Press the Temperature Adjustment button again to decrease the temperature. 4. 3. 7 Spin speed selection Whenever a new programme is selected, the recommended spin speed of the selected programme is displayed on the Spin Speed indicator. It is possible that the recommended spin speed value is not the maximum spin speed that can be selected for the current programme. 88 C 1888 0 88:88 Press the Spin Speed Adjustment button to change the spin speed. Then, depending on the model of the product, "Rinse Hold" and "No Spin" options appear on the display. C Spin Speed Adjustment button only serves for decreasing the spin speed. Rinse Hold option is indicated with “ı_ı” symbol and No Spin option is indicated with “_” symbol. If you are not going to unload your laundry immediately after the programme completes, you can use Rinse Hold function in order to prevent them from getting wrinkled when there is no water in the machine. This function holds the laundry in the final rinsing water. 46 / EN Washing Machine / User’s Manual 88 C 0 88:88 If you want to spin your laundry after the Rinse Hold function: - Adjust the Spin Speed. Machine spins the laundry by discharging the water. If you want to discharge the water at the end of the programme without spinning, use No Spin function. 88 C 0 88:88 You can change the spin speed after the washing starts if the washing steps allow it. Changes cannot be made if the steps do not allow it. Rinse Hold If you are not going to unload your clothes immediately after the programme completes, you can use rinse hold function to keep your laundry in the final rinsing water in order to prevent them from getting wrinkled when there is no water in the machine. Press Start / Pause button after this process if you want to drain the water without spinning your laundry. Programme will resume and complete after draining the water. If you want to spin the laundry held in water, adjust the Spin Speed and press Start / Pause button. [. . . ] • There may be problem in the valves or in the detergent dispenser. • Mix 1 tablespoonful softener and ½ l water and pour into the main wash compartment of the detergent drawer. • Put detergent into the machine suitable for the programmes and maximum loads indicated in the “Programme and consumption table”. When you use additional chemicals (stain removers, bleachs and etc), reduce the amount of detergent. [. . . ]