User manual SMEG WX634/1

[. . . ] CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. All safety messages will inform you of potential hazards, on how to reduce the risk of injury and what can occur if the instructions are not followed. IMPORTANT: Installation and grounding must comply with applicable codes. Observe all government codes and ordinances. - This appliance is intended for home use only. [. . . ] The manufacturer is not responsible for damages caused by improper use of this oven. This appliance complies with current safety requirements. Improper use of the appliance can lead to personal injury and material damage. Read all the instructions before installing or using the oven for the first time. Keep these operating instructions in a safe place and pass them on to any future user. WARNING - - SAVE THESE INSTRUCTIONS 4 Important Safety Instruction 2. GENERAL INSTALLATION INSTRUCTIONS · Proper installation is your responsibility. Have a qualified technician install this oven. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with installation guidelines specified on the model/serial ID plate. The model/serial ID can be found on the internal frame of the oven when the door is opened. 1. It is important to follow these instructions before and during the oven installation: · Decide on the final location of the oven. Locate the existing wiring to avoid drilling into or severing wiring during installation. · To avoid damage to the floor, place the oven on cardboard prior to installation. Do not lift by the door handle or any part of the frame or trim. · Remove the shipping materials and tape from the oven. · Remove the literature contained in the package. · Remove and set aside racks and other parts from inside the oven. · Move the oven on the cardboard close to the oven's final location. · Remove the oven door (see paragraph "9. 2 Removing the door" in the Instructions for the User booklet) IMPORTANT: Use both hands to remove the oven door. 6 Instructions for the Installer 4. MAKING THE ELECTRICAL CONNECTION ELECTRICAL SHOCK HAZARD WARNING - Disconnect power to the junction box before connecting Electrically ground the appliance with green or green-yellow wire FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DEATH, FIRE OR ELECTRICAL SHOCK. This appliance is manufactured with a yellow-green or green ground wire connected to the oven chassis. [. . . ] To prepare the connection between the oven and the junction box: Disconnect the power supply to the junction box, Feed the flexible cable conduit from the oven through the opening of the cabinet, Remove the junction box cover, if present, Install a UL-listed or CSA-approved conduit connector to the junction box, Route the flexible cable conduit from the oven to the junction box through a UL-listed or CSAapproved conduit connector. Tighten the screws on the conduit connector, Refer to figures 1 and 2 below, which represent the most common way of making the electrical connection. IMPORTANT: Any local codes and ordinances should be give priority over these instructions. NOTE: Frame grounded by connection of grounding wire to neutral wire. [. . . ]