User manual SMEG ZPAAFS020

[. . . ] If the supply cable is damaged it should be replaced by the manufacturer, the after-sales service or a suitably qualified person in order to avoid hazard. Once the kitchen hood has been installed, ensure that the mains cable to the network is not in contact with sharp metal edges. The fumes should not be extracted through pipes that are used to evacuate the fumes of gas (or another fuel) operated devices. [. . . ] Excessive fat accumulation in the kitchen hood and metal filters is a fire risk and may also cause dripping, therefore the inside of the kitchen hood and the metal filters must be cleaned at least once a month. The lower part of the kitchen hood must be fitted at least 65cm over gas or mixed hobs. FOLLOW THE HOBS´ MANUFACTURER'S MINIMUM RECOMMENDATIONS. Never leave gas hobs lit if not covered by a container. The fat accumulated in the filters may drip or catch fire when the temperature increases. Avoid cooking under the kitchen hood if the metal filters are not fitted, e. g. : while they are being cleaned in the dishwasher. You must not produce flames under the kitchen hood. Disconnect the appliance before any interior manipulation, e. g. We recommend the use of gloves and to be extremely careful when cleaning the kitchen hood's interior. To remove the filters from their fittings, press lightly on the locks and then pull them off. Cleaning the metal filters Cleaning the hood body Cleaning and maintenance The metal filters can be cleaned by soaking them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using special anti-grease products. They can also be washed in a dishwasher. In this case, it is advisable to stack them vertically to avoid food residues to stick to them. Cleaning in a dishwasher may damage the metallic surface (blackening it), although this will not affect its fat retention capacity. Once clean, leave them to dry off and then fit them onto the kitchen hood. Proceed as follows: · Remove the metal filters. · Change the broken/burnt out lamp. Changing light bulbs Problem solving Proceed with the following checks before calling the Technical Service: Problem The kitchen hood does not work. Possible cause The mains cable is not connected to the network. [. . . ] There is no current in the network. Solution Connect the mains cable to the network. Provide current to the network. The kitchen hood does not extract sufficiently or vibrates. Filters are saturated with fat. The lamps are slack. Remove the obstruction. [. . . ]