User manual SMITH CORONA DISPLAYCHAPTER2

[. . . ] Move the cursor using the Spacebar or Back Space to the desired left margin setting on the scale. Move the cursor using the Spacebar to the desired right margin setting on the typing scale. A beep confirms each new margin setting. You can change to Mem Mode, if desired. Margin L R Move Cursor to Desired Right Margin Margin L R Code + Smith Corona Corporation Page Layout -- 2-1 Tabs Up to eight tabs may be set. [. . . ] Tab (O) again for a Centered Tab ( TC ), or press Code + Spec. Tab (O) a third time for a Flush Right Tab ( F T ). Position Print Hammer on Regular Tab Code + O SpTab (once, twice, or three times) Changing a Special Tab to a Regular Tab 1. Position print hammer on the Special Tab to be changed. The tab will change to a Regular Tab, and the unit will beep once. Changing All Tabs to One Special Tab 1. Position the print hammer on left margin. Press Code + Sp Tab (O) until all tabs on the typing scale change to the tab desired. Changing All Special Tabs to Regular Tabs 1. Position the print hammer on left margin. All Special Tabs are changed to Regular Tabs. Removing One Tab Setting 1. Position the print hammer on that tab location by pressing Tab/Tab C. The tab symbol disappears from the scale. One beep is heard. Clearing All Tab Settings Press Code + Tab/ Tab C until 2 beeps are heard. If you are positioned at a tab stop you will hear 3 beeps. All tab symbols disappear from the scale. The display prompts: All Tabs Clear Smith Corona Corporation Page Layout -- 2-5 Format Settings End of Page Warning, Pitch, Line Spacing, and Impression Control are all set using the display and the setting indicators printed above it. Format settings are stored until you change them. You can set formats in both Type Mode and Mem Mode using the instructions below. Setting the End of Page Warning An End of Page Setting alerts you when you are approximately one inch from the bottom of the page in Type Mode by beeping 3 times. After you hear this warning, do not attempt to add additional lines of text. In Mem Mode, the unit will halt printing at approximately one inch from the bottom of the page for you to insert a new sheet of paper. End of Page can be set for 11" or 14" paper or can be turned off. 1. Format Code + + = Press Code + Format (+/=) to activate Format. The display illustrated below will appear. It shows the four vertical arrows, one for each format option. [. . . ] Press Code + Format (+/=) to activate Format (if not already activated). Press Return until the cursor is below the Impression option. Press Spacebar until the arrow points to your selection. Press Return to move to the next format option. [. . . ]