User manual SMITH CORONA OFFICE2000CHAP1

[. . . ] (See "Paper Support. ") 2. Tilt the sound shield (1) toward you. 3. 4. Remove the rubber band (left side first) from the tabs. Remove the carrier restraint card. 5. Remove the ribbon cassette. If the typewriter ribbon is slack, advance it by turning the gear wheel on the bottom of the cassette in the direction indicated. [. . . ] To activate the keyboard and select a mode, use the instructions below. Slide the Mode Selector from Standby ( ) to Type or Mem. The carrier (10) moves to the preset left margin. Slide the switch back to Standby ( ) when finished. NOTE: Line Mode can be accessed from Type or Mem Mode. See "Line Mode. " The Display The display is active in Type, Line, and Mem Modes. When in Type Mode, the display shows the typing scale and settings. A blinking cursor indicates the typing position. The left and right margin settings are marked by " L" and " R " respectively. End of Page Pitch Line Impression Keyboard OFF 10 1 M I 12 In Line Mode, the display shows the settings, typed text, and the cursor position. End of Page Pitch Line Impression Keyboard 11 10 1 M I 35 The quick brown fox jumped over the lazy dog. . . In Mem Mode, the display shows the file number, typed text, and the cursor position. End of Page Pitch Line Impression Keyboard File: RETURN to Enter/CURSOR 24000 for Directory 1-4 -- Hardware Basics Smith Corona Corporation Status Indicators In all modes, you can immediately find out which features are activated at any time. Active features are indicated by the symbols illustrated below. ­ Auto Return ­ Dictionary ­ Underscore All ­ Paragraph Indent ­ Punctuation Check For example, if the Spell-Right Dictionary, Auto Return, and Auto Underscore All are active, the display would look like this when the Status Indicator is used: End of Page Pitch Line Impression Keyboard ­ Bold Print ­ Underscore Word ­ Caps Lock ­ KBII Status A R A Activating the Status Indicator 1. The current status appears on the display. Release Code to deactivate the Status Indicator. Display Contrast You can adjust the intensity of your display by pressing and holding Code while pressing Adj (A). The display prompts: Contrast Adjust and begins to darken until the darkest level is reached; then, it reverts to the lightest setting and starts over. Release both keys when the desired contrast level is reached. Code + A Adj. Smith Corona Corporation Hardware Basics -- 1-5 Cursor The cursor appears on the display in all modes. In Type Mode, it is displayed as a rectangular box ( ), and in Line and Mem Modes, as a dash ( _ ). The cursor indicates where the next character will be entered. In Type Mode, this will be on the paper, but in Line and Mem Modes, it will be on the display. For reference, the cursor's numeric position is indicated on the top right-hand corner of the display in all modes. Volume Control Code + V You can adjust the volume of the beeps heard from your unit by pressing and holding Code while pressing V. The display prompts: Volume # (# lists a volume level from 0 through 10) Volume has been set on medium at the factory. When you set the volume level to 0, no beeps will be heard. When you change the volume level, the new setting you select is stored unless you select 0. If the unit is turned off when the value is set at 0 , the volume level will be reset to medium when it is turned on again. Automatic Paper Insert NOTE: Your typewriter easily handles 12" wide paper and a 9" typing line. [. . . ] The Lock light will come on when Lock is pressed. To deactivate Lock, press Lock or Shift. The light goes out. Caps Lock Caps Lock places the keyboard in a special mode that enables you to type numbers and capital letters without accessing the Shift and Lock keys. If you press the Shift key while Caps Lock is activated, you can type lower-case characters. [. . . ]