User manual SMITH CORONA OFFICE2000CHAP3

[. . . ] Do not press Return at the end of line. Deactivating Auto Return Press Code + Return (1). The Status Line prompts: Auto Return OFF. 3-2 -- Type Mode Smith Corona Corporation Text Enhancements Bold Print 1. A beep is heard, and the display prompts: Bold Print ON. To turn off bold print, press Code + Bold (B). [. . . ] New settings will replace any existing settings. (See "Page Layout. ") NOTE: If you change pitch, remember to change the printwheel. Corrections The typewriter can automatically correct all characters in a three line correction memory buffer. You can easily correct characters not in the buffer by performing an extra step (see "Off-Line Correction"). Remember to use Code + , Code + , Code + , Code + , Return, Back Space, and Spacebar when positioning the print hammer to make a correction. If you use the platen knob, the line count may be inaccurate. IMPORTANT: If you changed printwheels, be sure to insert the proper printwheel before making corrections. Position Print Hammer Erasing Character(s) in Correction Memory 1. Position the print hammer on the incorrect character, if necessary, and then press Correct. Hold down to continue erasing characters to the left. Do not use the platen knob to position the print hammer. Be sure to activate Bold or Underscore if you want the replacement text enhanced. Press Code + Reloc (Return) to quickly return to your previous typing position, if necessary. NOTE: You erase the correction memory buffer when you turn off the typewriter, use the Automatic Paper Insert feature, switch modes, or change pitch. Correct 2. Type Correction 3. Code + Return Reloc WordEraser ® Position Print Hammer This feature allows you to erase word(s) within the correction memory buffer. Position the print hammer on any character in the incorrect word or on the space to the right of the word. If you are correcting more than one word, position the print hammer on the right-most incorrect word. Press WordEraser once for each incorrect word. Be sure to activate Bold or Underscore if you want the replacement text enhanced. Press Code + Reloc (Return) to return to your previous typing position, if necessary. Smith Corona Corporation ® WordEraser LineEraser Type Correction 2. Code + Return 3. 4. Reloc 3-6 -- Type Mode LineEraser ® Using the LineEraser feature, you can easily remove an entire line of text located in correction memory. Position the print hammer on any character in the line. Correction begins immediately from the last character typed on the line up to the first character typed on the line. NOTE: You can press Code + Stop (S) to stop LineEraser. [. . . ] Position the print hammer to the first character in the series to be corrected using Code + , Code + , Code + , Code + , Spacebar, Return, and Back Space. Do not use the platen knob to position the print hammer. Two beeps are heard, and the display prompts: Forward Correct. At this point you can cancel correction by pressing Return. [. . . ]