User manual SMITH CORONA XD6500 TYPEWRITER

[. . . ] 12 AUTO (Automatic Return) . . . . . . . . . . . . . . . . . . . . . 12 LP (Line Print) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 JUST (Justification) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 CHANGING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Pull this lever toward you and lift out the daisy wheel. 3) Place the daisy wheel into the slot with the characters facing the platen. 5) Press the CODE + = (SETTING) key. -56 Changing The Correction Tape 1) Move the print carrier to the center of the platen using the SPACE or . 2) To replace the correction tape, lift out the typing ribbon cassette (see Changing The Ribbon Cassette) and remove the two spools of the lift off tape by pulling them outwards. 3) Place the empty spool of new tape on the left pin so that the tape winds clockwise. Pull the tape around the right guide and place the loaded spool on the right pin so that the tape unwinds counterclockwise. 5 Make sure the sticky side of the tape is facing the platen. 4) Manually turn the left-hand spool in the clockwise direction, tightening the tape until resistence is felt. 6) Press the CODE + = (SETTING) key. 7 -6- BASIC FEATURES Selecting Pitch There are three pitches available for typing the CODE + 4 (PITCH) key is used to change the typing pitch. The selection sequence is the following: PICA ELITE MICRO PICA The chosen pitch will be displayed. PICA (10) : 10 characters per inch ELITE (12) : 12 characters per inch MICRO (15) : 15 characters per inch v v v Selecting Line Spacing There are three line spacing settings availble - 1, 1 1/2, 2. · Word Underline To activate, press the CODE + W key. All text except spaces will be underlined. To cencel, press the CODE + W key again. -910 TAB To set a tab, move the carrier to the desired position and press the TAB S key. To clear a tab, move the carrier to the tab position to be cleared and press the CODE + TAB C key. To clear all tab positions, press the CODE + TAB C key for half a second. Decimal Tab Decimal tab allows you to align numbers by decimal point at the tab position. The carrier will move to the next tab position. The characters you typed will be displayed. 3) When the decimal point (. ) is typed, the text will be printed out with the decimal point. 4) To print the text, press the RETURN , TAB or CODE + DEC TAB key. Centering Your typewriter allows you to automatically center a line. The carrier will move to the center position between the left and right margins. The characters you type will be displayed. [. . . ] Search To search a text press the CODE + S (SEARCH) key. You will then be asked by the display for which text you would like to search. Type the Text, then press the RETURN key. The display will show the first matching text after the cursor position. [. . . ]