User manual SOLAC AE2540

[. . . ] Always unplug the appliance by pulling on the plug, and not the cord. Make sure the cord does not come into contact with sharp edges or hot surfaces. Do not leave the cord hanging over the edge of a table or worktop, to prevent children from pulling it and causing the appliance to fall. Never use the vacuum cleaner without the dust container or the protective filters correctly fitted. [. . . ] Use the broom until the electronic device has disconnected the appliance and recharge the battery fully. Do not store or charge the appliance near radiators or other heat sources, or exposed to direct sunlight. Do not charge the appliance in dirty or damp places and make sure the temperature is between 0ºC and 37ºC. Do not vacuum toxic materials, such as n Before adding or removing accessories or performing any type of maintenance work, n Do not use the appliance on top of the power cable. 2 Select the necessary accessory, depending on the purpose for which you are going to use the broom (fig. Especially designed for sofas and other upholstered surfaces. Insert the multipurpose brush (19) in the suction outlet and push inwards until you hear a click. To remove it, press lightly on the multipurpose brush release button (20) and pull outwards. 3 Adapt the broom size as necessary by adjusting the length of the telescopic pole (15) (fig. Slide the handle release button (5) in the direction shown in the figure and pull the handle (4) in the opposite direction to extend the pole. Release the release button (5) when you have reached the desired length in order to lock the telescopic pole. To shrink the telescopic pole, slide the handle release button (5) in the direction shown in the figure and push the handle inside the main broom body. Release the release button (5) once you have finished. If during operation you hear a high-pitched whistle, different to the normal noise that the appliance makes, switch off and unplug the appliance. 5 Once you have finished vacuuming, switch off the appliance by placing the switch (3) in the OFF position. N Before you clean or perform any maintenance work on the appliance, ensure that it is For optimum performance, you are advised to clean the collector and filters after each use. When you need to empty the dust collector, ensure that the appliance is disconnected and proceed as follows: 1 Push the collector release button (11) downwards and remove the collector. 2 Remove the filter unit (12-13-14) by holding the collector firmly and pulling the filter tongue outwards. Shake the filter unit over a bin or use a brush to clean it thoroughly. 3 Once you have removed the collector filters, empty the collector into a bin. 4 To clean the filters thoroughly, remove the case (12) by rotating anticlockwise and remove the filter (13) from the bracket by pulling it outwards (fig. 5 If it is very dirty, wash the dust collector and the filters underneath running water using a gentle detergent (fig. [. . . ] These include labour costs and spare parts or the replacement of the appliance should either of the first two choices be impossible or impractical. The warranty shall be rendered null and void by any of the following: · If the corresponding bill of sale, receipt or delivery note is not provided or if the information on these documents is altered. If the appliance has been used for professional cleaning and not for domestic cleaning only. If the appliance has been taken apart or altered by anyone outside the technical service centres authorised by SOLAC. [. . . ]