User manual SOLAC AS3258

[. . . ] Before plugging the appliance into the mains, check that the indicated voltage is the same as in your home. Always unplug the appliance after use and before assembling or removing parts, and performing any maintenance or cleaning operations. also unplug it in the case of a power cut. The appliance must be switched off before plugging or unplugging it into the mains · do not use the cord to hang up the appliance. [. . . ] See the following section (Cleaning and Conservation) 2 Insert the flexible hose (13) into the connection (12) until it clicks into place When you want to remove the hose, press the release tabs (11) at the same time. It can be used on all types of floors, as it is retractile and can adapt to the surface to be cleaned. to change the cleaning position of the brush , press the brush button (25) with your foot. We recommend cleaning hard floors, wood and parquet with the fibre brush extended, and cleaning carpets and rugs with the fibre brush retracted. The length of the telescopic tube can be adjusted (20) by sliding the adjustment button (21) while moving both parts of the telescopic tube. 5 Pull the cord (5) out as far as the yellow mark (ideal length). If necessary, pull it out as far as the red mark, but no further. 7 Switch the vacuum cleaner on by pressing the foot button (2) and adjust the suction power by opening or closing the regulator on the handle (19). (Opening the valve reduces the power and closing it increases the power). ) If, while using the appliance, you hear a sharp whistle unlike the usual sound, turn it off and unplug it. check that the air intakes , outlets and filters are not blocked. If they are blocked, get rid of the cause of the blockage. , While using the appliance, drag it along like a trolley. Use the container handle (16) to carry the vacuum cleaner. , This appliance has a position known as "horizontal parking", which can be used for pausing from time to time during cleaning. This position is achieved by holding the telescopic tube by the hook in the groove (4) of the appliance body (fig. , All these accessories can be stored in the accessory holder (22) housed in the telescopic metal tube (fig. 8 Once you have finished, switch the appliance off by pressing the button (2). unplug it and press the button (3) to wind up the cord. Hold the cord plug in your hand to prevent it from banging against the vacuum cleaner housing. If for any reason the vacuum cleaner should overheat, the thermostat will automatically shut off the appliance. If this should happen: 1 Press the on/off switch (2) and unplug the appliance from the mains. [. . . ] 3 Gently tap the outlet filter against the side of the waste bin to remove any excess dirt and dust. ) Never use the vacuum cleaner without the air outlet filter. ) Clean the appliance before using it for the first time, immediately after each use and After not using it for a long period of time. You will thus ensure the correct operation of the appliance and prolong its useful life. [. . . ]