User manual SOLAC CT8646

[. . . ] The appliance must be switched off before plugging or unplugging it into the mains · do not use the cord to hang up the appliance. Always unplug the appliance by pulling on the plug, and not the cord. Make sure the cord does not come into contact with sharp edges or hot surfaces. Do not leave the cord hanging over the edge of a table or worktop, to prevent children from pulling it and causing the appliance to fall. [. . . ] Do not cover this product with plastic bags or any other covers. Do not use the product on an adjustable bed or, if you do use it on an adjustable bed, make sure the bed warmer and power cable do not get trapped or creased. This appliance is designed for household use only. Do not use this appliance for purposes other than those described in this manual. This product is not designed for medical use in hospitals or for use in excessively humid environments (tropical countries, etc) People who are insensitive to heat must be careful when using this appliance. The bed warmer should be used under direct supervision, especially if being used by persons who are disabled, insensitive to heat, sick or children. Do not use the appliance whilst under the influence of alcohol, sleeping pills or sedatives. Consult your doctor before using the appliance if you are pregnant or you suspect you could be pregnant, or if you suffer from any type of heart problem or serious illness. Prolonged application at maximum power can cause skin burns. When you want to dispose of the appliance, NEVER throw it in the rubbish bin. Take it to the CLEAN POINT or waste collection centre closest to your home for processing. You will thus be helping to take care of the environment. Position 1: 25º C Position 2: 30º C Position 3: 35º C Position 4: 40º C These temperatures are for guidance purposes only and may vary slightly while the appliance is in use. temperature position 4 is particularly suitable for preheating the bed. Positions 1, 2 and 3 can be used for constant operation while sleeping. 2 Disconnect the power cable from the bed warmer connector by pressing the button on the cable connector (3) (fig. 2b) 3 Unplug the power cable from the mains (2). z Allow the bed warmer to cool down before storing or cleaning. Automatic Safety Shut-Off For your safety, this bed warmer switches off automatically after 3 hours of continuous operation. Bed warmer Mains power cable (CT8646 has 2 units) Mains power cable connector (CT8646 has 2 units) Bed warmer connector (CT8646 has 2 units) Elastic mattress grips Control unit (CT8646 has 2 units) a ON/OFF switch b Temperature control button c Automatic safety shut-off pilot light. [. . . ] I There are 4 positions that correspond to the following temperatures: I It is advisable to wash the bed warmer only if it becomes dirty or dusty. If you wash it too often the product can wear out very quickly. (2): the power cable must NEVER come into contact with water. < When cleaning the bed warmer, ALWAYS unplug the power cable < Before using the bed warmer again, make sure it is completely dry. [. . . ]