User manual SOLAC EVOLUTION

[. . . ] € When you finish ironing, always empty the water from the tank. If you want to drain it while ironing, always unplug the appliance from the mains first. € Keep the CVG in an upright position during storage, leaning on its heel part, set on a stable surface. € To disconnect the CVG, never pull on the power cord, take out the plug. [. . . ] After the tank is full, close the cap (1). 3 Check the garment to be ironed to see if it has a label that indicates the ironing temperature. We recommend that you classify garments by their required ironing temperature and that you begin ironing with the garments that require the lowest temperature ( • ). sILK , WOOL , SYNTHETIC FIBRES , minimum temperature (•) POLYESTER , medium temperature (••) COTTON , max. Temperature (•••) LINEN, maximum temperature (MAX) ‹ Keep the water-filling hole lid (1) closed during operation. Z i NB: Ironing delicate garments with a temperature higher than necessary is harmful for i If you have any doubts about the temperature to use for a given garment, perform a test on a part which won’t be seen, beginning with the lowest temperature settings. The fabric and causes burnt residue to get stuck to the soleplate. Woolmark: The wool cycle of this iron has been approved by The Woolmark for the ironing of pure wool products provided that the products are to the instructions on the garment label and those issued by this iron. 12 MAIN COMPONENTS AND ACCESSORIES BOOKCVG9900. Book Page 13 Friday, April 16, 2010 1:59 PM OPERATION Designed exclusively for ironing clothes. €If the appliance is hot, handle it carefully and do not touch the hotplate. Book Page 14 Friday, April 16, 2010 1:59 PM i When taking your hand off the handle, the steam selector is not deactivated. Steam emission is only temporarily cut off until contact is detected once again on the handle. The screen continues to display the steam selector icon selected. tEMPORARY SWITCH OFF For temporary switch off during ironing. 1 Without touching the handle, press the steam selector for 3 seconds (6) (fig. All the icons will light up momentarily and a buzzer sound. All the icons on the display will then disappear. 2 Press the steam selector (5) for 3 seconds to switch on the CVG again. All the icons will light up momentarily and a buzzer sound. The CVG will be situated at Position and with the steam selector deactivated . z Z AUTOMATIC SWITCH OFF: AUTO - PAUSE The CVG has an automatic switch off system. [. . . ] Switch off the appliance and fill the water tank. When switching it on again, this noise will disappear. En Z Z OTHER FUNCTIONS ANTICALC SYSTEM The CVG is fitted with an innovative anticalc system consisting of a resin filter, which retains the limy substances in the water, preventing these from reaching the steam chamber in the soleplate and thereby extending the life of your CVG. The existence of this anticalc system does not mean you can ignore the advice on water hardness mentioned in the “BEFORE STARTING TO IRON” section. [. . . ]