User manual SOLAC RA8031

[. . . ] Do not use the appliance in the bathroom, near a washbasin or sink, or in a swimming pool. ⷠDo not cover with clothing to be dried. [. . . ] This can cause its temperature to increase dangerously. 2 You will find two metal plates attached to the bottom side of the radiator. Install one of the axles with wheels (6) on one of these metal plates, aligning the holes in both parts. Next, fasten the axle with wheels, using 2 wing nuts. Repeat this operation with the other axle (6) to complete the installation of the 4 radiator wheels. Before using the appliance for the first time, make sure Only connect the radiator to a socket that has a ground connection. connection 1 Plug the plug into the socket. Turn the power selector (3): ­ Position I ­ Minimum temperature - MIN ­ Position II ­ Medium temperature - MED ­ Position III ­ Maximum temperature - MAX 2 The power for the various levels, MIN (W), MED (W), MAX (W), is shown in Table 1. 3 To disconnect the appliance, turn the power selector to the position 0 and pull the plug out of the socket. Radiator Temperature selector Power selector Pilot light Carry handle Axle with wheels Wing nut Wheels Cable winder Unpack the appliance and remove all traces of the packaging that may remain in between the parts of the radiator. ⷠMake sure the radiator is not damaged and the plug is not deformed. When the room reaches the desired temperature, slowly turn the selector anticlockwise until the pilot light (4) goes out. You can leave the selector in this position. When the room temperature drops below the level marked on the thermostat, the radiator will come on automatically until the desired temperature is reached. [. . . ] Make sure the radiator is not connected to the mains, and Ensure they are correctly installed before using the appliance. 1 Carefully turn the radiator upside down on a carpet or any other soft surface, in order to avoid damaging the protective layer. [. . . ]