User manual SOMFY 24 V INSTALLATION GUIDE

[. . . ] This box is used to bring into compliance the doors fitted on industrial, commercial premises and garages in relation to the new European standards (NF EN 12445, NEF EN 12453, EN 12978, EN 13241) and French standards (NF P25 362). Hereby, SOMFY, declares that this equipment is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. [. . . ] Sequenced First pulse provokes opening, next pulse provokes stop, next pulse provokes closing etc. Similar to sequenced mode alone but with automatic gate closure after time-delay (parameter t0). In this operating mode, no safety device is activated except the emergency stop and torque limitation. Dril the attachment holes at the back of the box (5-mm drill bit) taking care not to damage the board. Incorrect fitting of the cables à through the glands may downgrade the IP55 protection index. 5 mm2 - Properly protected (fuse or circuit breaker rated at 10 A) with a differential device (30 mA), - Fit a single pole disconnection device standard EN 60335-1. - Installed according to the current electric safety standards. Power grid connection (terminals 1 and 2) must be performed as a final operation. 1 dry contact (230 Vac ­ Pmax = 500 VA) is available on tie-point block 6 (contacts 3 and 4). 1 supplied contact (24V/1, 5 A or 12V/3A) is available on tie-point block 9 (contacts 12 and 14) when using an opener or suction cup. This contact may be " NC " ou " NO " according to programmed settings. Autotest for 24 Vdc photoelectric cells is ensured by shutting down the 24 V power of the emitting cell (terminals 16, 17). [. . . ] Learning takes place under the control of the user, without cell safety device and without signalisation. Permet, dans le cas d'un portail à 2 vantaux, de retarder l'ouverture du deuxième vantail In the case of a two-door gate with overlap, this setting delays the opening of the second door Hiermee kan bij een hek met twee hekdelen de opening van het tweede hekdeel vertraagd worden Permite, en caso de un portal de 2 batientes, retardar la apertura del segundo batiente Value displayed Fonction 0 1 2 3 4 5 0 1 0 1 0 1 P4 P5 P6 P7 P8 P9 PA Pb A0 Motor torque setting 1 Motor torque setting 2 High speed setting motor 1&2 Low speed setting motor 1&2 Low speed position setting 00 to 10 (10) 00 to 10 (10) Automatic Semi-automatic Blockage Sequenced Sequenced and Timed Internal keyboard With time-delay Without time-delay 2 motors 1 motor Pressing `Valid' " activates the autolearning, H1 is displayed in the learning phase (c. [. . . ]