User manual SOMFY CODETASTER 5014046

[. . . ] A Declaration of Conformity is available at the web address www. somfy. com Heading CE Built-in manual security control Before connecting the unit, you must read the instructions carefully. A Mounting of the EOLIS receiver RTS 2 : Recommendations : 150 mm 150 mm 40 mm t Install the EOLIS receiver RTS with the cables entry pointing downwards to avoid water infiltration. t Do no install the eolis receiver RTS against a metallic part (it could affect the radio transmission). t minimum distance between the receiver and the floor : 1, 5 m. [. . . ] t minimum distance between the receiver and the floor : 1, 5 m. t minimum distance between the receiver and the roof : 30 cm. t minimum distance between the receiver and the transmitter : 30 cm. t minimum distance between two receivers : 20 cm. ® B Cabling of the EOLIS receiver RTS 2 : The EOLIS receiver RTS is compatible with all standard SOMFY motors. Cabling arrangements are shown in the diagram. Respect the electrical standards in force as well as the following points: - disconnect the mains before carrying out any work. - be careful to avoid static electricity which could damage some electronic components. - use flexible cables - ensure that no longitudinal forces act on the cable carriers after installation - do not forget to connect the earth wires. To record these positions, the EOLIS receiver RTS has to record the time for the awning to go from its top to the IP and also the time from its bottom one to the IP. RECORD THE INTERMEDIATE POSITION FROM THE TOP OF THE AWNING STOP Push simultaneoustly on the DOWN and IP button of the RTS control until the awning begins to move (about three seconds). Stop the awning at the intermediate position you wish with the RTS control (if necessary, adjust this position with v and w push buttons). IP 1 2s Push the IP button of the RTS control during two seconds. µ The EOLIS receiver RTS has memorized the 1st intermediate Non-binding document. Products and references in this document are subject to change without prior notice. Please consult SOMFY before using such references. © SOMFY 12/99 Set the awning at its UP limit with the RTS control. position. RECORD THE INTERMEDIATE POSITION FROM THE BOTTOM OF THE AWNING STOP Set the awning at its DOWN limit with the RTS control. Push simultaneoustly on the UP and IP button of the RTS control until the awning begins to move (about three seconds). Stop the awning at the intermediate position you wish with the RTS control (if necessary, adjust this position with v and w push buttons). IP 2 2s Push the IP button of the RTS control during two seconds. µ The EOLIS receiver RTS has memorized the 2nd intermediate position. REACH THE INTERMEDIATE POSITIONS DELETE AN INTERMEDIATE POSITION To delete an intermediate position, press briefly the IP button of the RTS control to reach the intermediate position you wish to delete, then press continuoustly the IP button of the control until the led stops blinking (approx. 8 sec. ). µ The concerned IP is deleted. IP1 or To reach one of the intermediate positions, set the awning is at its UP (for IP1) or DOWN (for IP2) limit, then press briefly the IP button of the RTS control. µ The awning will move and stop at the dedicated intermediate position. IP2 Diagnosis The LED on the RTS control does not light. [. . . ] Push simultaneoustly on the UP and IP button of the RTS control until the awning begins to move (about three seconds). Stop the awning at the intermediate position you wish with the RTS control (if necessary, adjust this position with v and w push buttons). IP 2 2s Push the IP button of the RTS control during two seconds. µ The EOLIS receiver RTS has memorized the 2nd intermediate position. REACH THE INTERMEDIATE POSITIONS DELETE AN INTERMEDIATE POSITION To delete an intermediate position, press briefly the IP button of the RTS control to reach the intermediate position you wish to delete, then press continuoustly the IP button of the control until the led stops blinking (approx. 8 sec. ). µ The concerned IP is deleted. IP1 or To reach one of the intermediate positions, set the awning is at its UP (for IP1) or DOWN (for IP2) limit, then press briefly the IP button of the RTS control. µ The awning will move and stop at the dedicated intermediate position. IP2 Diagnosis The LED on the RTS control does not light. [. . . ]