User manual SOMMERKAMP TS-788DX

[. . . ] Do not connect the appliance to the mains until the installation is fully complete. Always wear work gloves for all installation and maintenance operations. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or know-how, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. Children should be monitored to ensure that they do not play with the appliance. [. . . ] The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet grid. 15 Installation The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Operation Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area. Before beginning installation: • Check that the product purchased is of a suitable size for the chosen installation area. €¢ To facilitate installation, remove the fat filters and the other parts allowed and described here, dismantle and mount it. To remove see also the relative paragraphs. • Remove the active carbon (*) filter/s if supplied (see also relative paragraph). The timing is subdivided as follows: Speed 1, 20 minutes ("1" + a flashing dot appears on display) Speed 2, 15 minutes ("2" + a flashing dot appears on display) Speed 3 , 10 minutes ("3" + a flashing dot appears on display) Intensive speed, 5 minutes ("4" + a flashing dot appears on display) During the timed working, by pressing the push-button 1, the cooker hood turns OFF; if you press the push-button 2 the cooker hood will return to the set speed, if you press the pushbutton 4 the cooker hood will pass to Cooking mode. Grease filter signalling After a total of 80 working hours number "1" starts to flash on display. When this signal appears, the installed grease filter needs washing. To reset the signal keep the push-button 1 pressed for 3” until number "1" disappear from diplay. Carefull read and follow the Maintenance instruction of the filter. Charcoal filter signalling After a total of 320 working hours number "2" starts to flash on display. When this signal appears, the installed charcoal filter needs to be cleaned or replaced (according the model you own). To reset the signal keep the push-button 1 pressed for 3” until number "1" disappear from diplay. Carefull read and follow the Maintenance instruction of the filter. In case of contemporaneous signalling of both filters, numbers "1" and "2" will flash on display alternatively. To reset, carry out the above described procedure twice. [. . . ] During cooking the system reacts promptly to increases in Steam/Fumes and remains in the speed established for at least a minute before returning to the lower speed/switches off. When cooking is finished and the environmental parameters have returned to the levels preceding cooking, the system turns itself off. The system turns the hood off after 30 minutes if the parameters are close to the stand-by condition. aIR QUALITY CONTROL Mode: letter "A" appears on display. [. . . ]