User manual SONY ERICSSON USB CABLE DCU-11

[. . . ] DCU-11 Installation Guide for Windows® 2000 Important note: To avoid loss of data, do not remove the USB data cable from the PC or the phone during data transfer. [. . . ] and then select Next (Figure 3). Figure 3 7) Check Specify a location, and select Next (Figure 4). Figure 4 8) Select Browse and point to the location where the driver files were copied to in step 1 and select OK (Figure 5). For this illustration, we made a folder called DCU11_drivers and put the driver files inside the folder. C:\DCU11_drivers Figure 5 9) To continue, select OK (Figure 5). 10) Select Next (Figure 6) to continue with the installation. c:\dcu11_drivers\suscom. inf Figure 6 11) The driver files will load to the PC and the installation process is almost complete! Figure 7 12) To complete the installation select Finish (Figure 7). Restart your computer. Verifying installation on Windows® 2000 systems: 1. From the Start Menu, select "Settings" then "Control Panel", and then double click on the "System" icon. Select the "Hardware" tab and then "Device Manager". The USB Cable DCU-11 can be found under "Ports", with the COM-port number shown in parentheses. It may be necessary to enable this device in "Phone Monitor Options", found under "Control Panel". (Do this after installing the Sony Ericsson PC software applicable for your mobile phone from http://www. sonyericsson. com). [. . . ] The COM-port installed as an USB device is now enabled. [. . . ]