User manual SONY AC-SQ950D

[. . . ] ⷠUnplug the unit from the wall outlet if it will not be used for extended period of time. To disconnect the cord (mains lead), pull it out by the plug. Do not operate the unit with a damaged cord or if it has been dropped or damaged. ⷠBe sure that nothing metallic comes into contact with the metal parts of the unit or connecting plate. [. . . ] ⷠDo not place the unit in a location where it is: -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Vibrating · Do not use the supplied connecting cord DK-626 with any other AC power adaptor but this unit or car battery charger. The DK-626 operates normally only when used with this unit. If any difficulty should arise, unplug the unit and contact your nearest Sony dealer. This symbol is intended to alert the user to the presence of uninsulated "Dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ⷠTo ascertain the battery life, refer to the instruction manual of the video equipment which you use. ⷠThe charging time may differ depending on the condition of the battery pack or the temperature of the environment. When a fully charged battery pack is installed, the CHARGE lamp will once light, then go out. ⷠIf the CHARGE lamp does not light or flash, check that the battery pack is correctly attached to the AC power adaptor. If it is not attached it will not be charged. Remove the battery pack from this unit, then install the same battery pack again. If the CHARGE lamp lights and does not flash again: If the CHARGE lamp goes out because the charging time has passed, there is no problem. If the CHARGE lamp lights and does not flash again: If the CHARGE lamp goes out because the charging time has passed, the problem is with the battery pack first installed. Please contact your nearest Sony dealer in connection with the product with the problem. ­ To use anytime you need See illustration B. Connect this unit to the video equipment using the supplied DK-626 connecting cord. [. . . ] Install the battery pack to the video equipment and turn off the power of the video equipment. 1 Connect the power cord to a wall outlet. The battry indicator in the display window of the video equipment will light and charging of the battery pack installed in the video equipment will begin. You can charge a battery pack attached to this unit and another battery pack installed in the video equipment simultaneously. [. . . ]