User manual SONY AC-VQ800

[. . . ] To remove the connecting plate, slide it up while pressing the battery release lever C. To prevent fire or shock hazard, do not expose the unit to rain or moisture. AC power cord must be changed only at the qualified service shop. When the mode change switch is set to VTR/CAMERA during charging, charging stops. [. . . ] Slide the battery pack in the direction of the arrow, then lift it straight out. Slide the battery pack in the direction of the arrow, then lift it straight out. While charging, you can check the charging time on the display. After starting charging in a minute, BATTERY LIFE lights up on the display. 3 Connect the power cord to a wall outlet. The beep sounds and the display window lights up. Each time you press DISPLAY CHANGE, the display changes as follows. This symbol is intended to alert the user to the presence of uninsulated "Dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. When the remaining battery indicator becomes and the CHARGE lamp lights up, normal charge is completed. For full charge, which allows you to use the battery slightly longer than "normal charge", leave the battery pack attached until the CHARGE lamp goes out. It can be used even if the charging is not completed. The remaining battery time when the battery pack being charged is attached to your InfoLITHIUM video equipment The time is not displayed when the remaining battery time is less than 5 minutes. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. The Graphical Symbols with Supplemental Marking is located on the bottom of the unit. This unit cannot be used to charge a Ni-Cd/Nickel hydrogen type battery pack. Charge the battery pack on a flat surface without vibration. However, to provide maximum battery efficiency, the recommended temperature range when charging is 10°C to 30°C (50°F to 86°F). This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] You may wait for a while after pressing DISPLAY CHANGE until the display shows the time indication. ⷠTo display the remaining battery time of a new battery, attach it to your video camera recorder and use it for about 20 seconds. Then, charge the battery with this unit. When you install the battery pack, be sure to not strike it to the terminal of the AC adaptor/charger. [. . . ]