User manual SONY AC-VQ900AM

[. . . ] To reduce fire or shock hazard, do not expose the unit to rain or moisture. The AC Power cord must only be changed at a qualified service shop. The power plug is disconnected from the wall outlet. When using a digital single lens reflex camera, the battery life may vary considerably depending on the method of use. [. . . ] ⷠUnplug the unit from the wall outlet if it will not be used for extended period of time. To disconnect the cord, pull it out by the plug. Do not operate the unit with a damaged cord or if it has been dropped or damaged. Use the connecting cord with the ferrite core attached to prevent unnecessary radio waves from being emitted. If any difficulty should arise, unplug the unit and contact your nearest Sony dealer. If the CHARGE lamp lights and does not flash again: If the CHARGE lamp goes out because the charging time has passed, the problem is with the battery pack first installed. This symbol is intended to alert the user to the presence of uninsulated "Dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. For how to check the battery life, refer to the instruction manual of your video equipment. ⷠThe charging time may differ depending on the condition of the battery pack or the ambient temperature. ⷠThe approximate times shown are when charging an empty battery pack with this unit at 25 °C (77 °F). ⷠApproximate minutes to charge an empty battery pack fully (Full charge). To ascertain the battery life, refer to the instruction manual of the video equipment which you use. Please contact your nearest Sony dealer in connection with the product with the problem. The unit's function of displaying the battery life is available when using in combination with "InfoLITHIUM" compatible equipment (mainly camcorders). Battery packs marked "SQ" also support SuperQuick charging, which is faster than normal or quick charging. When the mode change switch is set to VCR/CAMERA during charging, charging stops. ⷠIf the CHARGE lamp does not light or flash, check that the battery pack is correctly attached to the AC adaptor/charger. If it is not attached it will not be charged. ⷠQuick charging is only performed with "InfoLITHIUM" battery packs. ⷠIf anything goes wrong during charging, the charge lamp blinks and "WARNING" appears on the display. The "InfoLITHIUM" is a lithium ion battery pack which can exchange data with compatible electronic equipment about its battery consumption. Sony recommends that you use the "InfoLITHIUM" battery pack (M series) with electronic equipment having the mark. [. . . ] ⷠThis unit may not be compatible with some equipment (digital single lens reflex cameras, etc. Using the unit as an AC Adaptor If you set the mode change switch to CHARGE while operating the camera, the power supply to the camera stops. ⷠYou cannot charge the battery pack attached to this unit if you set the mode change switch to VCR/CAMERA. ⷠKeep this unit away from the equipment you are using if the picture is disturbed. [. . . ]