User manual SONY AC-VQP10 annexe 1

[. . . ] 1 Place the battery pack on this unit with the b mark facing the terminal. Slide the battery pack in the direction of the arrow, then lift it straight out. Do not pick up the AC adaptor/charger by the battery pack when there is a battery pack installed. ⷠBe particularly careful not to hit the battery when installing it. [. . . ] Please contact your nearest Sony dealer in connection with the product with the problem. This unit cannot be used to charge a Ni-Cd/Ni-MH type battery pack. Charge the battery pack on a flat surface without vibration. A battery pack attached only in Slot 1 This symbol is intended to alert the user to the presence of uninsulated "Dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. this symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The Graphical Symbols with Supplemental Marking is located on the bottom of the unit. This unit complies with quick charging, but charging outside the recommended temperature range will lead to longer charging times in order to protect the battery pack. Once the charging time has been extended, it will not return to quick charging even if the temperature is brought within the recommended temperature range. Design and specifications are subject to change without notice. Use a commercially available AC plug adaptor, if necessary, depending on the design of the wall outlet. The remaining time until normal charge of the first attached battery pack is complete The normal charge time is not displayed after the normal charge is complete. The negligible amount of electric current will flow into the AC adaptor/ charger as long as the AC adaptor/charger is plugged into the wall outlet. ⷠUnplug the unit from the wall outlet if it will not be used for extended period of time. To disconnect the cord, pull it out by the plug. Do not operate the unit with a damaged cord or if it has been dropped or damaged. ⷠUse this unit near to a wall outlet. This is to ensure that the power plug can be immediately unplugged from the wall outlet to turn the power off if some abnormality occurs during use. Be sure that nothing metallic comes into contact with the metal parts of the unit or connecting plate. If it does, a short may occur and the unit may be damaged. Keep the unit away from AM receivers, because it will disturb AM reception. ⷠDo not place the unit in a location where it is: -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Vibrating · Placing this unit in locations subject to the direct sunlight such as on dashboards or near heating apparatus may cause this unit to deform or malfunction. If any difficulty should arise, unplug the unit and contact your nearest Sony dealer. [. . . ] When charging starts, the battery mark in the display window will, in order, blink and the internal CHARGE lamp on the main unit will be lit. when charging , all of the battery marks will be lit (Normal charge). In addition, the internal CHARGE lamp will go out; continuing to charge until "FULL" is displayed in the battery mark (in about 1 hour) will allow the unit to be used even longer (Full charge). This unit allows attachment of two battery packs simultaneously. [. . . ]