User manual SONY ACC-CSFG

[. . . ] To prevent fire or shock hazard, do not expose the unit to rain or moisture. For the customers in the USA CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Flip up the power plug and insert it into the wall outlet. ­ For the customers in the other countries: The shape of the plug on the end of the power cord may differ from the illustration, depending on the country where you purchased the unit. Plug the appropriate end of the power cord into the battery charger, then plug the other end of the power cord into the wall outlet. When charging begins, the CHARGE lamp of the compartments containing batteries will light up; the CHARGE lamps will go out when charging is finished. When the CHARGE lamp doesn't light, or when it blinks on and off, refer to "Troubleshooting, " on page 10 (GB). 3 After the batteries are fully charged, unplug the power plug, open the cover , and remove the batteries. ­ For the customers in the USA, Canada and Japan: When charging is completed, fold the power plug and store inside the unit. ­ For the customers in the other countries: When unplugging the power plug, be sure to hold the plug. This charger allows quick charging when either one or two Sony HR11/45, HR03 (size AAA), NH-AAA or Sony HR15/51, HR6 (size AA), NH-AA Nickel-Metal Hydride batteries are inserted. The times indicated are for batteries with the capacities listed below. This may result in overheating or other malfunction. If the ambient temperature is outside the range of 10°C to 30°C (50°F to 86°F), the batteries may not charge efficiently. Do not install or store the battery charger in locations with the following conditions: · Locations with extremes of temperature Leaving the unit in direct sunlight, in a closed automobile, or near heatproducing devices, may result in deformation or malfunction of the unit. Locations subject to strong magnetism · Locations subject to dust or sand If you use the battery charger, for example, on a beach or in a desert, make sure that you keep the battery charger away from any sand. A battery charger that is covered with sand may cause a malfunction. Because the battery charger may cause noise, do not use it near televisions or AM radio tuners. Do not allow metal to come in contact with the connecting part of this unit. To clean the battery charger, use a soft cloth or tissue paper. If needed, use a soft cloth dampened with diluted mild detergent, then wipe the unit with dry cloth. Using these chemicals may damage the battery charger. If you use a chemically treated cleaning cloth, follow the instructions. Do not let rubber or vinyl touch the battery charger. [. . . ] It is better to prepare enough batteries for two or three times the length of time you plan to use the unit. If fact, the colder it gets, the more battery performance decreases, and the shorter the length of time the batteries can be used. When you are not using the unit To protect the batteries, remove them from the unit. If left in place, the batteries may leak. [. . . ]