User manual SONY ACV-Q50

[. . . ] ⷠIf the CHARGE lamp does not light or flash, check that the battery pack is correctly attached to the AC adaptor/charger. If it is not attached it will not be charged. Design and specifications are subject to change without notice. Use a commercially available AC plug adaptor, if necessary, depending on the design of the wall outlet. [. . . ] Refer to these numbers whenever you call upon your Sony dealer regarding this product. If the CHARGE lamp lights and does not flash again: If the CHARGE lamp goes out because the charging time has passed, there is no problem. To prevent fire or shock hazard, do not expose the unit to rain or moisture. The model for USA and Canada: One blade of the plug is wider than the other for the purpose of safety and will fit into the power outlet only one way. If you are unable to insert the plug fully into the outlet, contact your dealer. If the CHARGE lamp lights and does not flash again: If the CHARGE lamp goes out because the charging time has passed, the problem is with the battery pack first installed. While charging the battery pack, this unit will show the remaining battery time with your video equipment, etc. Using the InfoLITHIUM battery pack · Using the video equipment having the mark Make sure that you use the battery pack having the mark. consult the operating instructions supplied with your video equipment if it is applied to InfoLITHIUM. Though the following models are applied to InfoLITHIUM, the remaining battery time is not displayed on this unit. dCR- SC100/SC100E/TRV7/TRV7E CCD- TR555/TR555E/TR610E/TR710/TR710E/TR760E/TR790E/TR810E/ TR820E/TR825E/TR910/TR910E/TR920E/TR930/TR1100E/ TR2200E/TR2300/TR2300E/TR3100E/TR3300/TR3300E/TR3400/ TRV31/TRV31E/TRV41/TRV41E/TRV51/TRV51E/TRV54E/ TRV56E/TRV61E/TRV62/TRV64E/TRV72/TRV81/TRV81E/ TRV82/TRV91E/TRV94/TRV94E/TRV101/TRV101E/ SC55/SC55E/SC65/SC65E GV-A500/A500E If you use the video equipment having the mark, the remaining battery time display of the battery pack being charged corresponds to the video equipment having the mark which is last attached to the battery pack. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. The negligible amount of electric current will flow into the AC adaptor/ charger as long as the AC adaptor/charger is plugged into the wall outlet. ⷠUnplug the unit from the wall outlet if it will not be used for extended period of time. To disconnect the cord, pull it out by the plug. Do not operate the unit with a damaged cord or if it has been dropped or damaged. ⷠBe sure that nothing metallic comes into contact with the metal parts of the unit or connecting plate. If it does, a short may occur and the unit may be damaged. Keep the unit away from AM receivers, because it will disturb AM reception. ⷠDo not place the unit in a location where it is: -- Extremely hot or cold -- Dusty or dirty -- Very humid -- Vibrating If any difficulty should arise, unplug the unit and contact your nearest Sony dealer. [. . . ] Full charge requires about 1 hour after normal charge is completed. If you remove the battery pack between normal charge and full charge, the charging time may not be displayed properly in the next charging. When you attach a fully charged battery pack to this unit, "TIME TO CHG FULL 1h" may appear on the display. ⷠThe remaining battery time may not be displayed depending on using conditions and circumstances of your video camera recorder and of the battery. [. . . ]