User manual SONY AC-VF10

[. . . ] If the CHARGE lamp does not light up or flash, check that the battery pack is correctly attached to the AC Adaptor/Charger. If it is not attached correctly, it will not be charged. ⷠIf anything goes wrong during charging, the charge lamp blinks and "WARNING" appears on the display. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. [. . . ] You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Before operating the unit, please read this manual thoroughly and retain it for future reference. The AC-VF10 AC Adaptor/Charger can be used as follows: · Connection cords are included with this unit to operate Sony equipment (video camera, etc. The following functions are available when charging "InfoLITHIUM" battery packs. ⷠWhile the unit is in use, it gets warm. Unplug the unit from the wall outlet after use. To disconnect the cord, pull it out by the plug. Connect this unit to an available wall socket. Even though the CHARGE lamp of this unit is off, it is not disconnected from the power source. If any trouble occurs while the unit is in use, unplug it from the wall socket to disconnect the power source. ⷠThe negligible amount of electric current will flow into the AC adaptor/ charger as long as the AC adaptor/charger is plugged into the wall outlet. ⷠUnplug the unit from the wall outlet if it will not be used for extended period of time. To disconnect the cord, pull it out by the plug. Do not operate the unit with a damaged cord or if it has been dropped or damaged. If any difficulty should arise, unplug the unit and contact your nearest Sony dealer. [. . . ] When two battery packs are installed but not simultaneously, charging starts with the battery pack installed first regardless of whether it is in Slot 1 or 2. For the direction in which to fit the connecting cord, refer to the operating instructions of video camera etc. Setting the mode change switch to CHARGE while operating the video equipment cuts the power supply to the video equipment. ⷠYou cannot charge a battery pack installed in this unit when in VCR/ CAMERA mode. [. . . ]