User manual SONY AITE90-UL

[. . . ] The model and serial numbers are located on the bottom. Record the serial number in the space provided below. Refer to them whenever you call upon your dealer regarding this product. Information WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. [. . . ] Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. All other system names, products, and services are either registered trademarks or trademarks of their respective owners. The TM or ® marks do not appear in this manual. How to Use this Guide The drive can also read data recorded with other devices. You can therefore connect the drive to either connector to your computer. The drive can also read data recorded with other devices. You can therefore connect the drive to either connector to your computer. The drives support Hot Plug, which means that you can connect and disconnect it while the drives and/or your computer is on. The actual degree of compression during recording depends on the system environment and the type of data. The following are the minimum system requirements to use the drives. When using the NT backup:Windows XP, Windows 2000, or Windows Server 2003 When using the 1SafeTM: Windows XP, Windows 2000, Windows Me, or Windows 98 SE · The AITe130V-UL can be used with data cartridges marked with the AIT-1 or AIT-2 logo. The AITe90V-UL can be used with data cartridges marked with the AIT-1 logo. Be sure to use only data cartridges designed specifically for AIT. Do not use anything but AIT cartridges with this system, as doing so can damage the AIT drive. Although commercially available 8mm videotapes resemble AIT cartridges in appearance, they have entirely different specifications and cannot be used. Push to remove a data cartridge from the drive. After you confirm that all the necessary items are accounted for, connect the drives to the host computer or to a USB hub. When you open the package, make sure that it contains the following. Contact your supplier if any of these items are missing and/or damaged. Safety regulations *Warranty coverage may vary from region to region. Remove the two slotted screws by using a slotted screwdriver. ) After changing the DIP switch settings, replace access cover and tighten the two slotted screws using a slotted screwdriver. [. . . ] The POWER indicator should light, and the TAPE MOTION, CLEANING REQUEST, and REPLACE TAPE indicators should blink as the self-test is performed. If the drives behave abnormally, or if it begins to smell or smoke, immediately unplug it from the wall outlet and contact your supplier for assistance. For heavy dirt, wipe with a soft cloth moistened with a gentle liquid soap, then wipe again with a soft dry cloth. Do not use alcohol, paint thinner, bug sprays or other volatile solvents, as they can damage the finish. [. . . ]