User manual SONY AITI130

[. . . ] This document contains proprietary information which is protected by copyright. No part of this document may be photocopied, reproduced or translated to another language without prior written consent of Sony. [. . . ] After removing the drive from the computer, repack the drive into its original packing. The AITi130 conforms to the Microsoft PC97 standard which requires the internal (naked) drive to be terminated with an external terminator. Both internal and external cable ends are instead terminated by plug-in connectors. Note : = CLOSED/Jumper = OPEN/Jumper not installed Don't care Control by host can be disabled when position 8 [DC Control (2)] is ON. There are three LED indications (BUSY, TAPE and STATUS) and an EJECT button on the front panel of the unit. Insert a cassette into the slot on the front panel with the arrow on the cassette pointing towards the drive. As the cassette is inserted, the drive takes it and automatically loads it into drive mechanism. The cassette can be removed from the AITi130 either in response to a SCSI Unload Command, or by pressing the eject bottom. By pressing Eject button, the tape goes to BOT, the drive unthreads it, and ejects the cassette from the slot. Cassettes can be write-protected by sliding the tab on the back of the cassette. In this state, data can be read from the tape but not written onto it. AIT-1 AIT-2 Using your fingernail, push the switch in the direction of the arrow to protect the tape from writing or accidental erasure. [. . . ] Operating Less than 150 microgram/m3 Based Sampling period 24 hours * All phone numbers listed are in the USA. Add the country code (1) prior to those numbers when calling from outside the USA. [. . . ]