User manual SONY AITI260

[. . . ] sONY MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS DOCUMENT. Sony shall not be liable for error contained herein, indirect, special, incidental or consequential damages in connection with the furnishing, performance or use of this document. [. . . ] After removing the drive from the computer, repack the drive into its original packing. The AITi260 conform to the Microsoft PC97 standard which requires the internal (naked) drive to be terminated with an external terminator. microsoft PC97 SCSI requirements SCSI peripherals must not terminate the bus. Both internal and external cable ends are instead terminated by plug-in connectors. Note : = CLOSED/Jumper = OPEN/Jumper not installed Don't care Control by host can be disabled when position 8 [DC Control (2)] is ON. There are three LED indications (Tape Motion, Cleaning Request, Replace Tape) and an EJECT button on the front panel of the unit. Insert a cassette into the slot on the front panel with the arrow on the cassette pointing towards the drive. As the cassette is inserted, the drive takes it and automatically loads it into drive mechanism. The cassette can be removed from the AITi260 either in response to a SCSI Unload Command, or by pressing the eject bottom. By pressing Eject button, the tape goes to BOT, the drive unthreads it, and ejects the cassette from the slot. Cassettes can be write-protected by sliding the tab on the back of the cassette. In this state, data can be read from the tape but not written onto it. [. . . ] Otherwise the gear of the drive can be damaged. The sound-meter on (A) scale is located 1m in front of the center of the drive front panel. [. . . ]