User manual SONY AVD-K700P

[. . . ] 2-108-205-11(1) DVD/VCR Receiver Home Theater System Operating Instructions HT-V700DP ©2004 Sony Corporation Safety Precautions Warning To prevent fire or shock hazard, do not expose the unit to rain or moisture. CAUTION: This DVD/VCR Receiver employs a Laser System. To ensure proper use of this product, please read this owner's manual carefully and retain for future reference. Should the unit require maintenance, contact an authorized service location. [. . . ] Enter the new 4-digit password, then press ENTER. Enter exactly the same password a second time and verify by pressing ENTER. 1 2 3 4 5 Select rating to 8 using V/v buttons. 4 One (1)ahas thefrom 1playback restrictions. least Eight (8) has the most playback restrictions. Unlock: If you select Unlock, Parental Control is not active. Ratings 1 to 8: Some discs contain scenes not suitable for children. If you set a rating for the DVD, all disc scenes with the same rating or lower will be played. Higher rated scenes will not be played unless an alternative scene is available on the disc. The alternative must have the same rating or a lower one. If no suitable alternative is found, playback will stop. You must enter the 4-digit password or change the rating level in order to play the disc. ENTER to confirm selection, 5 Presspress SETUP/MENUyour rating menu. then to exit the If you forget your 4-digit password If you forget your password, to clear the current password follow the procedure below. 1 Press SETUP/MENU to display the setup menu. 2 Enter the 6-digit number "210499". The 4-digit password is cleared. 3 Enter a new password as shown above to the left (Rating). 23 PREPARATION Enter the code of an area whose standards were used to rate the DVD video disc, referring to the list (See "Area Code List", page 45. ). VIDEO Operation Playback Preparation: Turn on the TV. Tune the TV to the DVD/VCR Receiver output channel (CH 3 or 4) or set the TV's source selector to VIDEO. If a direct VIDEO/AUDIO connection is made between the DVD/VCR Receiver and the TV, set the TV's source selector to VIDEO. Set the Output Source to VIDEO as shown in "Selecting the Output/Input Source" on page 15. During high-speed picture search mode, a short period is needed to stabilize tape speed when re-entering the PLAY mode. Slight interference may be observed during this period. Search This function lets you quickly and visually search for a desired tape section in either direction: forward or reverse. The DVD/VCR Receiver will be activated in the SEARCH mode. If the DVD/VCR Receiver is left in the SEARCH mode for more than 3 minutes, the DVD/VCR Receiver will automatically enter the PLAY mode, to protect the tape and video heads. Note If you select "L1 OPT", this unit can not activate the playback mode. 1 Insert a prerecorded video cassette. The indicator will light and the DVD/VCR Receiver will power-up automatically. [. . . ] Adjust the antennas and connect an external antenna if necessary. The signal strength of the stations is too weak (when tuning in with automatic tuning). No stations have been preset or preset stations have been cleared (when tuning by scanning preset stations). The remote control does not work properly. [. . . ]