User manual SONY BC-CSQ3

[. . . ] ⷠAfter rechargeable batteries have been fully charged, quickly remove them from the charger. If you allow them to remain in the charger for a long time, the performance of the batteries may deteriorate. ⷠAt the time of purchase, or when the rechargeable batteries have not been used for a long time, they may not fully charge. This is typical of this type of battery, and is not a malfunction. [. . . ] ⭠Do not spray volatile material such as pesticide on the battery charger. Do not let rubber or vinyl touch the battery charger. Before operating the unit, please read this manual thoroughly and retain it for future reference. To prevent fire or shock hazard, do not expose the unit to rain or moisture. for the customers in the USA CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Do not touch the power plug during thunderstorms. ⷠMake sure to insert the power plug in the wall outlet properly. ⷠIf you are not going to use the battery charger, unplug the power plug. ⷠWhen you service the battery charger, unplug the power plug. If any difficulty should arise, unplug the battery charger and contact your nearest Sony dealer. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. ⭠Increase the separation between the equipment and receiver. ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. If you run into any problem using this battery charger, use the following table to solve the problem. Symptom The lamp does not light when plugging the charger with batteries. Something is wrong with either the batteries or the charger. This power unit is intended to be correctly orientated in a vertical or floor mount position. The lamp blinks when plugging the charger with no batteries. [. . . ] ⷠStore the batteries out of the reach of young children. ⷠIf you notice the batteries have leaked, changed color or changed shape, do not use them. The shape of the plug on the end of the power cord may differ from the illustration, depending on the country/region where you purchased the battery charger. Plug the appropriate end of the power cord into the battery charger, then plug the other end of the power cord into the wall outlet. [. . . ]