User manual SONY BC-TR1

[. . . ] For a full charge, which allows you to use the battery longer than usual, leave the battery pack in place for approximately another one hour (Full charge). Do not connect the power plug of this unit with the prong of the plug at the bottom (See Illustration C). Owner's Record The model and serial numbers are located on the bottom. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. [. . . ] This may result in overheating or other malfunction. Notes on Use This unit does not have dust-proof, splash-proof or waterproof specifications. Precautions on Use · Connect the battery charger to an available wall outlet. Even though the CHARGE lamp of this battery charger is off, it is not disconnected from the power source. If any trouble occurs while the unit is in use, unplug the battery charger from the wall outlet to disconnect the power source. · This unit cannot be used to charge a nickel cadmium type, or nickel metal hydride type battery pack. · Attach the battery pack to the unit firmly when you charge the battery pack. · The battery terminal may be damaged if the battery pack is not attached correctly. · To protect the battery pack, remove the battery pack from the unit within 24 hours after the charging is completed. · Do not apply mechanical shock or drop the unit. · Keep the unit away from a TV or AM receivers. In particular, noise from the device may enter a TV or radio if it is placed nearby. · Unplug the unit from the wall outlet after use. Pull the unit out by the battery charger. · Be sure that nothing metallic comes into contact with the metal parts of the unit. If it does, a short may occur and the unit may be damaged. CHARGER V mark 2 Troubleshooting When the CHARGE lamp blinks, check through the following chart. Remove the battery that is being charged and firmly attach the same battery again. The CHARGE lamp blinks again: Install another battery pack. B C The CHARGE lamp lights up and does not blink again: If the CHARGE lamp goes out because the charging time has passed, there is no problem. The CHARGE lamp blinks again: The problem is with this unit. Where not to place this unit Regardless of whether this unit is in use or in storage, do not place it in any of the following locations. · Placing this unit in locations subject to the direct sunlight such as on dashboards or near heating apparatus may cause this unit to deform or malfunction. · Locations of excessive vibration · Locations with strong electromagnetism or radiant rays · Locations with excessive sand In locations such as the seashore and other sandy areas or where dust clouds occur, protect the unit from sand and dust. There is a risk of breakdown. The CHARGE lamp lights up and does not blink again: If the CHARGE lamp goes out because the charging time has passed, the problem is with the battery pack first installed. Please contact your nearest Sony dealer in connection with the product with the problem. Specifications Input rating Output rating Operating temperature Storage temperature Dimensions Mass 100 - 240 V AC 50/60 Hz 6W Battery charge terminal: 4. 2 V DC 0. 7 A 0 °C to +40 °C (+32 °F to +104 °F) ­20 °C to +60 °C (­4 °F to +140 °F) Approx. 47 × 36 × 72 mm (w/h/d) (1 7/8 × 1 7/16 × 2 7/8 inches) Approx. 70 g (2. 5 oz) Included items Battery Charger (BC-TR1) . . . . . . (1) Set of printed documentation Maintenance · Wipe the unit with a soft dry cloth when it is dirty. [. . . ] Alignez le repère de batterie V dans le sens du repère de chargeur V et insérez la batterie dans le sens de la flèche (Voir l'illustration A-1). Après l'avoir bien enfoncée, appuyez légèrement dans le sens de la flèche jusqu'à ce qu'elle s'encliquette (Voir l'illustration A-2). 2 Relevez la fiche et raccordez-la à une prise secteur (Voir l'illustration B). Le témoin CHARGE (orange) s'allume et la recharge commence. [. . . ]