User manual SONY BC-TRV

[. . . ] This unit cannot be used to charge a nickel cadmium type, or nickel metal hydride type battery pack. Attach the battery pack to the unit firmly when you charge the battery pack. The battery terminal may be damaged if the battery pack is not attached correctly. [. . . ] Keep the unit away from a TV or AM receivers. In particular, noise from the device may enter a TV or radio if it is placed nearby. Unplug the unit from the wall socket if it will not be used for extended period of time. To disconnect the mains lead, pull it out by the plug. Be sure that nothing metallic comes into contact with the metal parts of the unit. If it does, a short may occur and the unit may be damaged. Check if the battery pack is attached to this unit firmly when the CHARGE lamp does not light. When a fully charged battery pack is installed, the CHARGE lamp will light up once, then go out. When charging a battery pack which has not been used for a long time, it may take longer than usual to charge. Battery pack Batterie BATTERY V mark Repère de BATTERY V Battery release button Bouton de libération de la batterie AC input terminal Borne d'entrée CA Design and specifications are subject to change without notice. Contents of the recording cannot be compensated if recording or playback is not made due to a malfunction of the battery pack, battery charger, etc. Charging by attaching the battery pack to this unit. (See Illustration A-2) 2 Connect the mains lead to the battery charger and then to a wall socket. (See Illustration B) The CHARGE lamp (orange) will light up and charging will begin. When the CHARGE lamp goes out, normal charging is completed (Normal charge). For a full charge, which allows you to use the battery longer than usual, leave the battery pack in place for approximately another one hour (Full charge). Push the battery release button V forward and remove the battery. NOTICE FOR THE CUSTOMERS IN THE UNITED KINGDOM A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. [. . . ] Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS1362 (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. Never use the plug without the fuse cover. [. . . ]